Abstract:Multi-directional cyclic loads, as often experienced by piles supporting offshore wind turbines (OWTs), could reduce global soil-pile stiffness, and jeopardize the serviceability of OWTs. Most of the existing p-y models focus on uni-directional soil-pile interaction, with a few multi-directional models developed at the cost of additional parameters that require unusual tests for multi-directional cycling. This study presents a multi-directional bounding-surface based cyclic model for lateral soil-pile interaction in both sand and clay. It can model multi-directional cyclic hysteresis and shakedown using only six parameters, without requiring extra parameters and tests for multi-directional cycling. This is achieved by introducing several uni-directionally loaded springs around the pile at each depth. The cyclic p-y relation for multi-directional loading is derived from that for uni-directional loading, by solving equations on equality of work required for the two models under a given displacement increment. The proposed model is validated against experimental results on piles under uni- and multi-directional cycling with various load- and displacement-controlled paths. It is found that following change of loading direction, the pile displacement accumulation is not only limited to the new loading direction, but includes transverse cycling towards the direction of least soil stiffness softened by the recent loading directions. The transverse cycling causes an additional reduction in the global soil-pile stiffness, facilitating the accumulation of lateral pile displacement.

Effect of Excavation Unloading on P-Y Curves for Laterally Loaded Piles

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Performance of laterally loaded H-piles in sand

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Analytical Elastoplastic Solutions of Laterally Loaded Long Piles

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

EFFECT OF EXCAVATION BENEATH EXISTING BUILDINGS ON LOADING STIFFNESS OF PILES

Effect of Unloading on the Shaft Resistance of Existing Piles Due to Deep Excavation

Field Tests on Lateral Monotonic and Cyclic Loadings of Offshore Elevated Piles

Analysis of Soil Movement Around a Loaded Pile Induced by Deep Excavation

Behavior Analysis of Laterally Loaded Single Pile under Large Deflection

A Multi-Axial Bounding Surface P-Y Model with Application in Analyzing Pile Responses under Multi-Directional Lateral Cycling

Development of cyclic p–y curves for laterally loaded pile based on T-bar penetration tests in clay

Centrifuge Study Ofp–ycurves for Vertical–horizontal Static Loading of Piles in Sand

Effects of deep excavation on uplift capacity of piles by centrifuge tests

Accuracy of Interpretation Methods for Deriving P–y Curves from Model Pile Tests in Layered Soils

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils