Surface Nanobubbles Produced by Cold Water Investigated Using Scanning Transmission X-ray Microscopy

Limin Zhou,Xinya Wang,Shin Hyun-Joon,Lijuan Zhang,Jun Hu
DOI: https://doi.org/10.1017/s1431927618014587
IF: 4.0991
2018-01-01
Microscopy and Microanalysis
Abstract:Surface nanobubbles have received extensive attention in the past decade due to their large contact angle and long-term stability which is inconsistent with macroscopic theories. [1-4] Potential applications like surface cleaning, water pollution recovering, promoting plant growth and mineral flotation have raised significant industrial interest. [5-8] However, the commonly used techniques like transmission electron microscopy and atomic force microscopy cannot reveal the chemical composition of nanobubbles. Disputing about whether nanobubbles are indeed gas filled bubbles or other contaminations like oil droplets has caused a large confusion in the nanobubble community. Herein, synchrotron based scanning transmission X-ray microscopy (STXM) was used to investigate the gas composition inside nanobubbles and their behavior. Surface nanobubbles are produced on a reduced graphene oxide (rGO) coated silicon nitride surface with cold water method. This is a very simple and clean method to produce nanobubbles. [9] Produced interfacial nanobubbles could be imaged near O K edge by STXM with a resolution of 50nm. Surface nanobubbles which are immersed in water can be resolved at 540eV. It was also found that small nanobubbles are very stable under the x-ray irradiation while micron-sized bubbles are quite unstable and will grow larger with time. This phenomenon could be helpful to understand the superstability of surface nanobubbles. Further analysis of the near-edge spectra could provide valuable information about the chemical composition inside surface nanobubbles.
What problem does this paper attempt to address?