Electrical Surface Breakdown Characteristics of Micro- and Nano-Al2O3 Particles Co-doped Epoxy Composites
Guobao Zhang,Wei Yang,Lei Zhang,Zhengyang Wu,Mengyi Cai,Taiyun Zhu,lei sun,He Gao,Zhen Li
DOI: https://doi.org/10.1088/1361-6463/ad773e
2024-09-05
Journal of Physics D Applied Physics
Abstract:Epoxy microcomposites are basic materials for GIS spacers that are subjected to huge electrical stress. Previous works have indicated nano-particles are benefits to dielectric performance. However, the surface electrical breakdown that is a typical failure form for GIS of co-doped micro- and nano-particles in epoxy composites is seldom studied. In this work, numerous concentrations of micro- and nao-Al2O3 are co-doped into epoxy matrix, and surface trap, surface charging, and surface breakdown voltages (Vsb) of the co-doped composites are studied, and the influence of micro- and nano-Al2O3 on electrical surface breakdown are clarified. The results show the Vsb first decreases and then increases with the microparticles, and the Vsb decreases from 25.34 kV to 19.52 kV. As the nanoparticles increase, Vsb increases and then decreases when the microparticle loading is low, but decreases and then increases when the microparticle loadings exceed 40wt%. Micro-Al2O3 particles introduce surface shallow traps into epoxy composites, while small amounts of nano-Al2O3 introduce deep traps. Two different mechanisms dominate surface charging and Vsb of epoxy micro-nano-composites. When the surface conductivity is lower than 7×10-14 S, surface charges are reduced by suppression of electrode injection as the trap depth increases, Vsb increases. As the surface conductivity exceeds 7×10-14 S, the surface charge dissipation rate increases with the surface conductivity and Vsb increases as surface conductivity increases. The work indicates co-doped micro- and nano-particles should keep the surface conductivity deviate from 7×10-14 S while maintaining its mechanical properties for GIS spacer.
physics, applied