Abstract:Pile-supported embankment is popularly used for constructing high-speed railways on soft soils. With train running at high speed, the dynamic load on the pile top generated by the train passages increases noticeably. To keep the long-term settlement of the railway track within a reasonable range, it is necessary to investigate the settlement of piles in soils simultaneously subject to the monotonic load caused by the weight of the track structure and embankment as well as the cyclic load caused by the train passages. In this paper, model tests on piles in silt soil under combined monotonic and cyclic loading were conducted. The behavior of a pile in saturated silt was investigated by measuring pile settlement, soil pressure on the pile surface, and pore water pressure in the soil adjacent to the pile. Based on the model testing results, the ratio of the mean value of cyclic load to the ultimate bearing capacity of the pile (P-m/P-u) and the ratio of the half amplitude of the cyclic load to the ultimate bearing capacity of the pile (P-cyc/P-u) were identified as the main factors dominating the development of pile settlement. A higher P-cyc/P-u leads to faster accumulation in the pile settlement, and a higher P-m/P-u facilitates this process. A chart with three zones determined by the combination of P-cyc/P-u and P-m/P-u has been proposed to distinguish the settlement trends of the piles: stable zone, metastable zone and unstable zone. The combination of P-cyc/P-u and P-m/P-u located in the stable zone generates very small settlement. Moreover, for the loading combination in the metastable zone, an analytical model was proposed to predict the cyclic pile settlement subject to cyclic load with large cycles. The advantage of the model is that the coefficient of friction at the pile surface and the cyclic strain degradation parameter are incorporated. Finally, a case study is presented to demonstrate the application of the proposed chart and the prediction method on cyclic pile settlement in the design of piled embankment of high-speed railways.

Finite Element Analysis of Lateral Earth Pressure on Sheet Pile Walls

Dynamic Behaviors of Piled Embankment Under High-Speed Train Loads

Analytical Elastoplastic Solutions of Laterally Loaded Long Piles

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Calculation of Earth Pressure Considering Time and Arching Effect on Pile-Anchor Supporting Structure

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Elastoplastic Analytical Computation of Long Piles under Combined Lateral Loads

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Study of Passive Earth Pressures Against Translating Rigid Retaining Walls in Narrow Excavations

Investigation on lateral pressure on a sheet-pile wall with EPS layer supporting an expansive soil slope

A Field Investigation on an Expansive Soil Slope Supported by a Sheet-Pile Retaining Structure

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings

Elastic Solutions for Partially Embedded Single Piles Subjected to Simultaneous Axial and Lateral Loading

Behavior Analysis of Laterally Loaded Single Pile under Large Deflection

Investigation on the feasibility of an alternative pile-sheet wall with circular piles for cutting slopes along high-speed railway

Study on parameters optimization of sheet pile earth retaining wall with a relieving platform based on its mechanical characteristics

Sectional Shape Effects of Steel Sheet Pile Walls on Earth Pressure by Centrifuge Model Tests

Experimental Study on Cyclic Settlement of Piles in Silt Soil and Its Application in High-Speed Railway Design

Backcalculation of Finite-Element Modeling Based on Field Measurements Results of Excavation in Steel Sheet Pile Walls

Earth Pressure Reduction and Transmission Between Rows of Portal Anti-Slide Piles