Abstract:Urban intersections are one of the most common sources of traffic congestion. Especially for multiple intersections, an appropriate control method should be able to regulate the traffic flow within the control area. The intersection signal-timing problem is crucial for ensuring efficient traffic operations, with the key issues being the determination of a traffic model and the design of an optimization algorithm. So, an optimization method for signalized intersections integrating a multi-objective model and an NSGAIII-DAE algorithm is established in this paper. Firstly, the multi-objective model is constructed including the usual signal control delay and traffic capacity indices. In addition, the conflict delay caused by right-turning vehicles crossing straight-going non-motor vehicles is considered and combined with the proposed algorithm, enabling the traffic model to better balance the traffic efficiency of intersections without adding infrastructure. Secondly, to address the challenges of diversity and convergence faced by the classic NSGA-III algorithm in solving traffic models with high-dimensional search spaces, a denoising autoencoder (DAE) is adopted to learn the compact representation of the original high-dimensional search space. Some genetic operations are performed in the compressed space and then mapped back to the original search space through the DAE. As a result, an appropriate balance between the local and global searching in an iteration can be achieved. To validate the proposed method, numerical experiments were conducted using actual traffic data from intersections in Jinzhou, China. The numerical results show that the signal control delay and conflict delay are significantly reduced compared with the existing algorithm, and the optimal reduction is 33.7% and 31.3%, respectively. The capacity value obtained by the proposed method in this paper is lower than that of the compared algorithm, but it is also 11.5% higher than that of the current scheme in this case. The comparisons and discussions demonstrate the effectiveness of the proposed method designed for improving the efficiency of signalized intersections.

Coordinated Control Model of Main-Signal and Pre-Signal for Intersections with Dynamic Waiting Lanes

Traffic Signal Control Optimization Strategy Based on Simulation

Proactive Coordination of Traffic Guidance and Signal Control for a Divergent Network

Coordinated Optimization of Signal Timings for Intersection Approach with Presignals

A Semi-"Smart Predict, then Optimize" Method for Traffic Signal Control.

Integration of Model-Based Signal Control and Queue Spillover Control for Urban Oversaturated Signalized Intersection

Traffic Signal Coordination Control for Arterials with Dedicated CAV Lanes

A Cooperative Optimization Model for Variable Approach Lanes at Signaled Intersections Based on Real-Time Flow

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Minimum Cycle Length of Two-Phase Road Intersection

Isolated intersection control based on hybrid optimization model

A Group-Based Signal Timing Optimization Model Considering Safety for Signalized Intersections with Mixed Traffic Flows

Optimization Method of Signal Timing Parameters Considering Comprehensive Efficiency of All Approach Lanes

Simulation of the Frontage Road Control Near the Expressway Exit Ramp

Intersection control strategy optimization based on exchangeable lanes modeling

Analysis of a Signalized Intersection with Dynamic Use of the Left-Turn Lane for Opposite through Traffic

Coordinated Arterial Dilemma Zone Protection Through Dynamic Signal Timing Optimization

Minimizing the Average Delay at Intersections Via Presignals and Speed Control

Multi-Objective Optimization Method for Signalized Intersections in Intelligent Traffic Network

Signal Control Study of Oversaturated Heterogeneous Traffic Flow Based on a Variable Virtual Waiting Zone in Dedicated CAV Lanes

Optimization of Control Parameters for Adaptive Traffic-Actuated Signal Control