Abstract:To improve the permeate flux and to keep the advantage of the high thermal efficiency in air gap membrane distillation (AGMD) for desalination, the optimal design of countercurrent AGMD of the hollow fiber module (AGMD-HF) is proposed. The module is basically composed of hydrophobic porous fiber tubes for feed flow and nonporous tubes for cold flow. The set of mathematical model equations for the entire module is derived from rigorous mass, momentum, and energy balances of both the feed side and the cold side coupled with the simultaneous mass and heat transfer across the membrane. The temperatures across the membrane and along the length of the module are simulated. The sensitivity of the process performance to operating conditions along the fiber length is investigated over a range of temperature and the flow rate. It is found that in the AGMD-HF domain, air/vapor dominates the heat and mass transfer resistances, which are comparable with the available experimental results in the literature. An attempt is then made to adjust the packing density and the surface ratio of the hot porous fibers to the cold nonporous fibers in order to maximize the process performance. Based on the trade-off between productivity and the thermal efficiency under module parameters, optimal design of AGMD-HF using Pareto solutions and the genetic algorithm is finally carried out. The obtained optimal points show that productivity increases considerably at the cost of the higher thermal efficiency with the increase of both packing density of the module and the tube ratio of hot feed fibers to cold fibers, with the latter showing relatively complex effect.

Sustainable Operation of Membrane Distillation for Hypersaline Applications: Roles of Brine Salinity, Membrane Permeability and Hydrodynamics

Membrane Distillation-Crystallization of Seawater Reverse Osmosis Brines

Conducting thermal energy to the membrane/water interface for the enhanced desalination of hypersaline brines using membrane distillation

Spatial variations of DCMD performance for desalination through countercurrent hollow fiber modules

Boosting membrane distillation lifespan: Superhydrophobic micro-nano surface construction and concentrate concentration management

Modeling and optimization of hollow fiber DCMD module for desalination

Interplay of the Factors Affecting Water Flux and Salt Rejection in Membrane Distillation: A State-of-the-Art Critical Review

Synergy of feed-side aeration and super slippery interface in membrane distillation for enhanced water flux and scaling mitigation

Wetting, Scaling, and Fouling in Membrane Distillation: State-of-the-Art Insights on Fundamental Mechanisms and Mitigation Strategies

Numerical Simulation and Optimal Design of AGMD-Based Hollow Fiber Modules for Desalination

Research on the Performance and Computational Fluid Dynamics Numerical Simulation of Plate Air Gap Membrane Distillation Module

Experimental Investigation on Floating Solar-Driven Membrane Distillation Desalination Modules

Direct Contact Membrane Distillation Mechanism for High Concentration NaCl Solutions

Enhanced Performance of Membrane Distillation Using Surface Heating Process

Conductive heating vacuum membrane distillation for brine desalination: Study on operational conditions, temperature polarization and energy consumption

Revisiting Scaling of Calcium Sulfate in Membrane Distillation: Uncertainty of Crystal-Membrane Interactions

Recent Progress in Electrospun Nanofibers for the Membrane Distillation of Hypersaline Wastewaters

Mass Transfer Analysis of Air-Cooled Membrane Distillation Configuration for Desalination

Membrane Scaling and Wetting in Membrane Distillation: Mitigation Roles Played by Humic Substances

Ultra-antiwetting Membrane for Hypersaline Water Crystallization in Membrane Distillation

Exergetic analysis of direct contact membrane distillation (DCMD) using PVDF hollow fiber membranes for the desalination brine treatment