Abstract:During the casting of high aluminum steel, the dramatic increase in the Al2O3/SiO2 ratio is inevitable, resulting in significant changes of the crystallization behavior, which would result in heat transfer and lubrication problems. Crystallization products and structure characterization of glassy CaO-SiO2-based mold fluxes with different Al2O3/SiO2 ratios were experimentally investigated using a differential scanning calorimetry technique and Raman spectroscopy. With increasing Al2O3/SiO2 ratios, the following results were obtained. The crystallization temperature and the crystallization products are changed. With increasing Al2O3/SiO2 ratios from 0.088 to 0.151, the crystallization temperature first increases greatly from 1152 °C to 1354 °C, and then moderately increases. The crystallization ability of the mold flux is strengthened. The species of the precipitated crystalline phase change from two kinds, i.e., Ca4Si2O7F2 and Ca2SiO4, to four kinds, i.e., Ca4Si2O7F2, Ca2SiO4, 2CaO·Al2O3·SiO2 and Ca12Al14O32F2, the crystallization ability of Ca4Si2O7F2 is gradually attenuated, but other species show the opposite trend. The results of Raman spectroscopy indicate that Al3+ mainly acts as a network former by the information of [AlO4]-tetrahedral structural units, which can connect with [SiO4]-tetrahedral by the formation of new bridge oxygen of Al–O–Si linkage, but there is no formation of Al–O–Al linkage. The linkage of Al–O–Si increases and that of Si–O–Si decreases. The polymerization degree of the network and the average number of bridging oxygens decrease. Further, the relatively strong Si–O–Si linkage gradually decreases and the relatively weak Al–O–Si gradually increases. The change of the crystalline phase was interpreted from the phase diagram and structure.

Effect of the Al2O3/SiO2 Mass Ratio on the Crystallization Behavior of CaO-SiO2-MgO-Al2O3 Slags Using Confocal Laser Scanning Microscopy

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

A Kinetic Study of the Effect of ZrO 2 and CaO/Al 2 O 3 Ratios on the Crystallization Behavior of a CaO-Al 2 O 3 -Based Slag System

Crystallization Behavior of the CaO-Al2O3-MgO System Studied with a Confocal Laser Scanning Microscope

Polymeric Structure Evolution Behavior Analysis of Aluminosilicate-Based Smelting Slag

Observations of Crystallization in Mold Slags with Varying Al2O3/SiO2 Ratio

Molecular Dynamics Simulation on the Influence of Al2o3 on the Slag Structure at 1873 K

Effect of CaO/MgO on Rheological Properties and Structure of CaO-MgO-SiO2-Al2O3-50% TiO2 Slag with SiO2/Al2O3=1.0

Effect of Al2o3/Sio2 Ratio on the Viscosity and Structure of Slags

Effect of W(mgo)/w(al2o3) Ratio and Basicity on Microstructure and Metallurgical Properties of Blast Furnace Slag

Crystallization Products and Structural Characterization of CaO-SiO2-Based Mold Fluxes with Varying Al2O3/SiO2 Ratios

Effect of Content of Al2O3 and MgO on Crystallization of Blast Furnace Slag During Fiber Formation

Flowability and Structural Evolution of CaO-SiO2-MgO-Al2O3 Slag with Varying MgO/CaO Ratios:Experiments and MD Simulations

Fluidity and Structure of Aluminate Slags for Smelting High-Alumina Iron Ores: Effect of CaO/SiO2 Mass Ratio

Crystallization Products and Structural Characterization of CaO-SiO₂-Based Mold Fluxes with Varying Al₂O₃/SiO₂ Ratios.

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Effect of Al 2 O 3 and CaO/SiO 2 on the Viscosity of Calcium-Silicate–Based Slags Containing 10 Mass Pct MgO

Understanding the Relationship Between Structure and Thermophysical Properties of CaO-SiO 2 -Mgo-al 2 O 3 Molten Slags

Crystallization Behaviors and Properties of Ti-bearing Blast Furnace Slag-Based Glass Ceramics with Varying CaO/SiO2 Mass Ratio

Investigation on Crystallization of CaO‐Al2O3‐B2O3‐BaO Slag Using Differential Scanning Calorimeter and In Situ High‐Temperature Raman Spectroscopy

Effect of SiO2 and B2O3 on crystallization and structure of CaF2-CaO-Al2O3-based slag for electroslag remelting of ultra-supercritical rotor steel