Abstract:Renewable generation, such as solar and wind, is intermittent, which causes sudden and unanticipated changes to power output and contributes to electricity grid instability. The stability and reliability of electricity grids requires a continuous balance between energy supply and demand. The aqueous lithium-ion battery (LIB) may solve both the safety problem associated with lithium-ion batteries that use highly toxic and flammable organic solvents, and the poor cycling life associated with commercialized aqueous rechargeable batteries including lead-acid and nickel-metal hydride systems. Aqueous LIBs have been demonstrated to be one of the most promising stationary power sources for the sustainable energy such as wind and solar power. As early as in 2005, we developed a new concept hybrid electrochemical supercapacitor in which a Li-ion intercalated compound was used as a positive electrode in combination with an activated carbon negative electrode in a Li2SO4 aqueous electrolyte (ZL. 200510025269.6). A hybrid cell consisting of a spinel LiMn2O4 positive and an AC negative electrode shows excellent reversibility with a sloping voltage profile from 0.8 to 1.8 V at an average voltage near 1.3 V, and delivers an 8 Wh/kg of 60000 F practical cell. In order to improve the specific energy, we employed LiTi2(PO4)3, but the cell shows poorer cycling stability compared with the pure AC anode. We found that, in the presence of oxygen, the discharged state of lithium-ion intercalated compounds (LIC) of all negative electrode materials will react with water and O2 despite of the pH value of the electrolyte, which is mainly responsible for the capacity fading of aqueous lithium-ion batteries during charge/discharge cycling. By eliminating the O2 (using a sealed cell), adjusting the pH values of the electrolyte, and using carbon-coated electrode materials; the LIB shows much cycling stability. A commercialized hybrid LIB shows a specific energy of ca. 30 Wh/kg, and exhibits a good cycling stability over 3500 cycles. In 2005, we also for the first time employed carbon coating technology to improve the electrode performance of Li4Ti5O4. By optimizing the graphitization and the coated carbon layer thickness, the nano-thickness carbon layer coated LTO shows excellent rate capability and less gas generation during cycling and storage. A LMO/LTO Li-ion battery show excellent cycling stability, high power and safety as stationary power source for smart-grid systems. References: Xia et al., TiP2O7 and Expanded Graphite Nanocomposite as Anode Material for Aqueous Lithium-Ion Batteries. ACS Appl. Mater. Interfaces, 9, 8075-8082 (2017). Xia et al., Raising the Cycling Stability of Aqueous Lithium-Ion Batteries by Eliminating O2 in the Electrolyte ”, Nat . Chem . , 2, 760-765 (2010). Xia et al., Hybrid aqueous energy storage cells using activated carbon and lithium-intercalated compounds I. The C/LiMn2O4 system, Electrochem. Soc. , 153(2): A450-A454 (2006).

A Stable High-Power Na2Ti3O7/LiNi0.5Mn1.5O4 Li-ion Hybrid Energy Storage Device

Pseudocapacitance-Enhanced High-Rate Lithium Storage in "Honeycomb"-Like Mn2o3 Anodes

High Performance Hybrid Mg-Li Ion Batteries with Conversion Cathodes for Low Cost Energy Storage

High-Performance Lithium Storage Based on the Synergy of Atomic Thickness Nanosheets of Tio2(B) and Ultrafine Co3o4 Nanoparticles

Low-potential and High-capacity Lithium Battery Anode Based on Hierarchical Assemblies of Na2TiSiO5 Nanotubes

(IBA Technology Award) Energy Storage Batteries Using Mn and Ti Based Elelctrode Materials

A MOF-derived hollow Co<sub>3</sub>O<sub>4</sub>/NiCo<sub>2</sub>O<sub>4</sub> nanohybrid: a novel anode for aqueous lithium ion batteries with high energy density and a wide electrochemical window

Nanoengineered Vanadium Oxide Composite as High-performance Anode for Aqueous Li-ion Hybrid Battery

High Power Lithium-ion Battery Based on Spinel Cathode and Hard Carbon Anode

Bioinspired Micro/Nanofluidic Ion Transport Channels for Organic Cathodes in High-Rate and Ultrastable Lithium/Sodium-Ion Batteries

A MOF-derived hollow Co3O4/NiCo2O4 nanohybrid: a novel anode for aqueous lithium ion batteries with high energy density and a wide electrochemical window

Unprecedented Superhigh‐Rate and Ultrastable Anode for High‐Power Battery via Cationic Disordering

Controllable Synthesis of TiO 2 @Fe 2 O 3 Core-Shell Nanotube Arrays with Double-Wall Coating as Superb Lithium-Ion Battery Anodes

Heterointerface Engineered Core-Shell Fe2O3@TiO2 for High-Performance Lithium-Ion Storage

SiO@C/TiO2 nanospheres with dual stabilized architecture as anode material for high-performance Li-ion battery

Nanochannel-confined Synthesis of Nb2O5/CNTs Nanopeapods for Ultrastable Lithium Storage

In Situ Constructed NiFe-LDH@Ti3C2Tx with a Three-Dimensional Network Structure: Enhanced Li+/Na+ Storage Via an Oxygen Bridge

Fabrication of hollow TiO2 nanospheres for high-capacity and long-life lithium storage

A SnO x Quantum Dots Embedded Carbon Nanocage Network with Ultrahigh Li Storage Capacity

A MOF-derived hollow Co 3 O 4 /NiCo 2 O 4 nanohybrid: a novel anode for aqueous lithium ion batteries with high energy density and a wide electrochemical window.

Nanoscale Borate Coating Network Stabilized Iron Oxide Anode for High‐Energy‐Density Bipolar Lithium‐Ion Batteries