Abstract:One of the most widely employed methods for adsorption is the utilization of biochar produced during pyrolysis. Biochar has attracted considerable attention due to its oxygen-containing functional groups and relatively high specific surface area. In alignment with the principles of cleaner production, the sludge generated from sewage treatment plants is typically classified as waste. However, it can be effectively repurposed as an adsorbent following pyrolysis and subsequent nanoparticle modification. This environmentally friendly approach presents an ecological alternative to conventional water treatment methods. The objective of this study is to evaluate the efficiency of batch adsorption for the removal of phosphate from wastewater using both unmodified and modified sewage sludge biochars (SSBs) that were produced at various temperatures (300 °C, 400 °C, 500 °C, and 600 °C) and modified with zero-valent iron nanoparticles (nZVI-SSB300, nZVI-SSB400, nZVI-SSB500, and nZVI-SSB600). The findings indicate that biochar modified with functional nanoparticles is a highly effective adsorbent for the removal of phosphate from wastewater. As demonstrated by the research results, the adsorption capacity of modified biochar is approximately 3 to 3.5 times greater than that of the unmodified variants. The phosphate removal efficiency with modified biochars was optimal with nZVI-SSB600. In experiments with a phosphate concentration (25 mg/L), the modified sorbent biochar exhibited an equilibrium adsorption capacity of 23.74 mg/g, translating to a phosphate removal efficiency of 60%. Under similar test conditions, at an initial phosphate concentration of 50 mg/L, the adsorption capacity improved to 25.67 mg/g (75% efficiency); at 75 mg/L, it reached 27.97 mg/g (80%); at 100 mg/L, it was 28.44 mg/g (85%); and at 125 mg/L, it achieved 29.48 mg/g (89%). The models confirmed the observed adsorption behavior, yielding a maximum phosphate adsorption capacity (qe) of 19.00 mg/g for the 600 °C pyrolysis of modified biochar at the primary phosphate concentration (25 mg/L). Furthermore, this study indicates that the influence of solution pH on phosphate adsorption remains stable and maximal (nZVI-SSB600, ranging from 16.87 to 20.46 mg/g) within the pH range of 3 to 8. On average, the modified biochar (nZVI-SSB) demonstrated 20 to 30% superior adsorption performance compared to the unmodified biochar (SSB). Additionally, significant differences were noted between various ambient temperatures, ranging from 5 °C to 25 °C. As the ambient temperature increased, the sorption capacity of the adsorbent exhibited a considerable improvement. With a primary concentration of phosphate (100 mg/g) at 5 °C, the adsorption capacity of nZVI-SSB600 was measured at 7.99 mg/g; this increased to 14.33 mg/g at 10 °C, 21.79 mg/g at 20 °C, and 28.44 mg/g at 25 °C. This research highlights the potential application of biochar in wastewater treatment for phosphate removal, simultaneously enabling the effective utilization of generated sewage sludge waste through pyrolysis and coating with zero-iron nanoparticles, resulting in a sustainable solution.

Adsorption Behaviors and Removal Efficiencies of Inorganic, Polymeric and Organic Phosphates from Aqueous Solution on Biochar Derived from Sewage Sludge of Chemically Enhanced Primary Treatment Process

Capacity and Mechanisms of Phosphate Adsorption on Lanthanum-Modified Dewatered Sludge-Based Biochar

Adsorption of phosphate over a novel magnesium-loaded sludge-based biochar

Zirconium-modified biochar as the efficient adsorbent for low-concentration phosphate: performance and mechanism

Effectiveness and Mechanisms of Phosphate Adsorption on Iron-Modified Biochars Derived from Waste Activated Sludge

Phosphate Removal from Polluted Water Via Lanthanum-Modified Sludge Biochar

Recovery of Phosphate From Aqueous Solution by Mg/Ca-Modified Biochar Derived From Dewatered Dry Sludge and Waste Almond Shells and Its Potential Application

β-FeOOH Modified Sludge Biochar as Efficient Adsorbent for Phosphate Removal

An Investigation of the Batch Adsorption Capacity for the Removal of Phosphate from Wastewater Using Both Unmodified and Functional Nanoparticle-Modified Biochars

Preparation of Iron Salt-Modified Sludge Biochar and Its Uptake Behavior for Phosphate

Enhanced Cu2+ and Cd2+ removal by a novel co-pyrolysis biochar derived from sewage sludge and phosphorus tailings: adsorption performance and mechanisms

Synergistic role of inherent calcium and iron minerals in paper mill sludge biochar for phosphate adsorption

Enhanced Phosphorus Bioavailability of Biochar Derived from Sewage Sludge Co-Pyrolyzed with K, Ca-rich Biomass Ash

Investigation into lanthanum-coated biochar obtained from urban dewatered sewage sludge for enhanced phosphate adsorption

Phosphate Removal Mechanisms in Aqueous Solutions by Three Different Fe-Modified Biochars

Removal of Phosphorus Using Biochar Derived from Fenton Sludge: Mechanism and Performance Insights.

Treating waste with waste: adsorption behavior and mechanism of phosphate in water by modified phosphogypsum biochar

Efficient Phosphate Adsorption at Wide Range of pH Values

Adsorption of Phosphates onto Mg/Al-Oxide/Hydroxide/Sulfate-Impregnated Douglas Fir Biochar

Simultaneous adsorption removal of organic and inorganic phosphorus from discharged circulating cooling water on biochar derived from agricultural waste

Adsorption of phosphorus in water by metal-modified large-size biochar: Realizing the recovery and recycling of phosphorus