Abstract:<p>Sandified soil slope in the semiarid ecosystems can affect overland flow velocity to accelerate soil erosion and increase sandification. For a better understanding of flow hydraulics in wind-water erosion zone of Loess Plateau, a computation method was suggested to estimate rill flow velocities over sand incorporation slope surface of sand-loess soil mixture. The sandified slopes involved three sand incorporation rates of 10%, 20%, 50%, as light, medium and severe levels of sandification, under four inflow discharges (1, 2, 4, and 8 L min<sup>−1</sup>) and four slope gradients (5°, 10°, 15°, and 25°). The measured electrolyte signals over sand incorporation surfaces were found to be initially smooth in the rising limbs. After the electrolyte solution arrived at the measurement location, part of the solute infiltrated into the surface sand layer. The electrolyte solute was absorbed by the sand layer before being slowly released into the water flow. This part should be deleted before overland flow velocity estimation. Compared with published data over loess slopes, velocities over sand incorporation surface were increased by an average of 69%, 54%, 30% for sand incorporation rates of 10, 20 and 50% respectively. Incorporation of sand particles into soil could have protected soil surface from being eroded to form rougher rill morphology, to increased flow velocity. But higher sand content also could have increased the surface frictional resistance to reduce the increase rate of overland flow velocity. For aeolian-sand incorporated loess slope, both linear regression and stepwise regression implied a positive dependency of velocities on flow rates and slope gradients, but a negative dependency on sand incorporation rates. The results will improve the understanding of overland flow hydraulics on sandified slopes.</p>

A study on velocity of aeolian sand particles over leeward slope by particle image velocimetry

Analysis of Sand Particles’ Lift-off and Incident Velocities in Wind-Blown Sand Flux

The influence of wind velocity and sand grain diameter on the falling velocities of sand particles

Measuring the Velocity of Particles in an Aeolian Saltation Cloud: A Comparison of Several Commonly Used Methods

Analysis of wind-blown sand movement over transverse dunes

Granular Pseudo-Fluid Large-Eddy Simulation Study of Aeolian Sand Transport Near a Bed Surface

Application of stereo PIV measurement to the aeolian sand transport

Influence of Sand Grain Diameter and Wind Velocity on Lift-Off Velocities of Sand Particles

Experimental Analysis of Sand Particles' Lift-off and Incident Velocities in Wind-Blown Sand Flux

Analysis of Lift-off Sand Particles Spin in Aeolian Saltation

Characterization of Wind‐blown Sand with Near‐wall Motions and Turbulence: from Grain‐scale Distributions to Sediment Transport

LES-DEM Study of 3-D Motion of Sand Particles Nearing Bed in Aeolian Sand Transport

Vertical Mass Flux Profiles of Different Grain Size Groups in Aeolian Sand Transport

Method for estimating overland flow velocity on sandified slopes from measured solute transport process with bias errors

Grain size and transport characteristics of non-uniform sand in aeolian saltation

Wind Tunnel Test of Sand Particle Size Distribution along Height in Blown Sand

Launch Velocity Characteristics of Non-Uniform Sand in Aeolian Saltation

Statistical Study on the Velocity of Aeolian Creeping Sands Using High-Speed Digital Photography

Incident Velocity and Incident Angle of Saltating Sand Grains on Mars

Vertical and horizontal profiles of grain size in aeolian sand transport

Numerical Simulation of Sand Dune Accumulation at Suoyang Ancient City