Abstract:Summary form only given.Recently, there is an increased interest in quantum dot sensitized solar cell (QDSSC), i.e., applying semiconductor quantum dots (QDs) in dye-sensitized solar cells [1]. However, QDSSCs have shown comparatively lower efficiencies than expected. One possible reason for the poor efficiency of QDSSC is the difficulty of assembling the QDs on ZnO surface to obtain a well-covered QDs monolayer. In this paper, we shall assemble CdS QDs by CBD method on bare and mercaptopropionic acid (MPA) modified ZnO nanorod films. We shall also compare the performance of these as-prepared QDSSCs. The method for fabrication ZnO nanorod has been reported elsewhere. The ZnO nanorod was grown by the hydrothermal method with the length of 2 μm. ZnO was immersed into 1M MPA/acetonitrile solution for 12 hours. The CBD process were described elsewhere [2], which involved dipping ZnO in a 0.5 M Cd(N03)2 ethanol solution for 15 min, rinsing it with ethanol, and then dipping it for another 15 min in a 0.5 M Na2S methanol solution, and rinsing it again with methanol. The two-step dipping procedure is considered as one CBD cycle. The photoelectrodes of ZnO/CdS, and ZnO/MPA/CdS prepared by their optimal CBD cycles were named as sample A and B. The carbon nanotubes screen-printed on ITO glass were used as counter electrodes. Fig. 1(a) and (b) shows the UV-vis absorption spectra of CdS-sensitized ZnO photoelectrodes prepared by various CBD cycles performed on bare and MPA-modified ZnO electrodes. It can be seen that the absorption range enlarged and steadily shifted to the longer wavelength with the increased CBD cycles. The absorbance of ZnO/MPA/CdS is higher that of ZnO/CdS electrode at the same CBD cycle, indicating that higher amount of CdS QD was deposited on MPA-modified ZnO. CdS QDSSCs were prepared by various CBD cycles performed on bare and MPA-modified ZnO electrodes. Fig. 2(a) and (b) shows the SEM images of ZnO nanorod modified with MPA before and after sen- itizing CdS QDs. From Fig. 2a it can be seen that, ZnO nanorods stand vertically on the substrate with 2 μm in length. After assembling with CdS QDs, the surface of ZnO nanorods is well covered by nanopaticles [in Fig. 2b]. It was reported that ZnO nanorod helps to improve the electron transport by avoiding particle-to-particle hopping that occurs in the Ti02 network. Fig. 3(a) and (b) show the I-V characteristics and the IPCE spectra of sample A and B at simulated one Sun (AM 1.5G, 100 mW/cm ). It can be seen that Jsc and Voc of ZnO/CdS and ZnO/MPA/CdS samples are 3.24 and 4.03 mA/cm2, and 0.532 and 0.601 V respectively. The FF and PCE of ZnO/MPA/CdS (28.8%, 0.70%) are higher than those of ZnO/CdS (23.4%, 0.41%). The details will be reported in the full manuscript.

Blocking the Formation of Zn2+/Dye Complexes in Dye-Sensitized Solar Cells by Inserting CdS Quantum Dots into Sandwich Layer

Multifunctional Zn(II)/Cd(II) metal complexes for tunable luminescence properties and highly efficient dye-sensitized solar cells

Synthesis and Characterization of Bi2S3 Quantum Dot-Sensitized TiO2 Nanorod Arrays Coated with ZnSe Passivation Layers

Advanced Cd-Ii Complexes As High Efficiency Co-Sensitizers For Enhanced Dye-Sensitized Solar Cell Performance

Enhancement in efficiency of CdS/CdSe quantum dots-sensitized solar cells based on ZnO nanostructures by introduction of MnS layer

Study of Quantum Dot/Inorganic Layer/Dye Molecule Sandwich Structure for Electrochemical Solar Cells

CdS Quantum Dots Sensitized Single- and Multi-Layer Porous ZnO Nanosheets for Quantum Dots-Sensitized Solar Cells

Facile one-step fabrication of CdS0.12Se0.88 quantum dots with a ZnSe/ZnS-passivation layer for highly efficient quantum dot sensitized solar cells

Synergistic Recombination Suppression by an Inorganic Layer and Organic Dye Molecules in Highly Photostable Quantum Dot Sensitized Solar Cells.

Enhanced Performance of Dye/qds Cosensitized Solar Cells Via Förster Resonance Energy Transfer

Inhibition of Charge Transfer and Recombination Processes in CdS/N719 Co-Sensitized Solar Cell with High Conversion Efficiency

CdS and CdSe Quantum Dots Subsectionally Sensitized Solar Cells Using a Novel Double-Layer ZnO Nanorod Arrays.

Highly Efficient Quantum Dot-Sensitized TiO2 Solar Cells Based on Multilayered Semiconductors (Znse/cds/cdse).

An Enhanced Degree of Charge Transfer in Dye-Sensitized Solar Cells with a ZnO-TiO2/N3/Ag Structure As Revealed by Surface-Enhanced Raman Scattering.

Highly Efficient Solid-State Solar Cells Based on Composite CdS-ZnS Quantum Dots

Cds/Cdse Quantum Dots and Znpc Dye Co-Sensitized Solar Cells with Au Nanoparticles/Graphene Oxide As Efficient Modified Layer

Quantum dot sensitized solar cell based on bifunctional linker modified ZnO nanorod array

Charge recombination control for high efficiency CdS/CdSe quantum dot co-sensitized solar cells with multi-ZnS layers.

Enhanced Absorption of CdS Quantum Dots Deposited Onto ZnO Nanorod by Using Bifunctional Linker

Combined Post-Modification of Iodide Ligands and Wide Band Gap ZnS in Quantum Dot Sensitized Solar Cells

The Photovoltaic Performance of Inorganic Quantum Dots and Organometallic Dye Co-sensitized Solar Cells