Abstract:With the development in additive manufacturing, the use of surface treatments for gas turbine design applications has greatly expanded. An experimental investigation of the pressure loss and heat transfer characteristics within impingement jet arrays with arrays of target surface micro cooling units is presented. The discharge coefficient and Nusselt number are measured and determined for an evaluation of the pressure loss of the flow system and heat transfer level, respectively. Considered are effects of impingement jet Reynolds number ranging from 1000 to 15,000 and micro cooling units (square pin fin) height (h) with associated values of 0.01, 0.02, 0.05, 0.2, and 0.4 D, where D is the impingement hole diameter. Presented are variations of Nusselt number, and Nusselt number ratio, discharge coefficient, discharge coefficient ratio, discharge coefficient correlation. Depending upon the micro cooling unit height, discharge coefficient ratios slightly decrease with height, and the ratio values generally remain unit value (1.0). When Rej = 1000 and 2500 for several cooling units height values, discharge coefficient ratios show the pressure loss decreases about 2–18% and 3–6%, respectively, when compared to the data of a baseline smooth target surface plate. The observed phenomenon is due to the effects of flow blockage of micro cooing units, local flow separation, and near-wall viscous sublayer reattachment. Results also show that heat transfer levels increase 20–300% for some of the tested toughened target surface plates when compared to smooth target surface plates. The heat transfer level enhancement is because of an increase in thermal transport and near-wall mixing, as well as the increased wetted area. In addition, micro cooling units elements break the viscous sublayer and cause greater turbulence intensity when compared to the smooth target surface. Overall, results demonstrate that the target surface micro cooling units do not result in a visible increment in pressure loss and reduce pressure loss of the flow system for some of the tested patterns. Moreover, results show the significant ability of micro cooling units to enhance the surface heat transfer capability of impingement cooling relative to smooth target surfaces.

Experimental Study of Jet Impingement Cooling with Carbon Dioxide at Supercritical Pressures on Micro Structured Surfaces

Numerical Investigation of Jet Impingement Cooling of a Low Thermal Conductivity Plate by Supercritical Pressure Carbon Dioxide

Experimental study of jet impingement boiling cooling with CO2 at subcritical pressures and comparisons with at supercritical pressures

Experimental investigation on heat transfer of an impinging jet of supercritical CO2 and comparison with liquid and gaseous CO2

Experimental Investigation of Micro Cooling Units on Impingement Jet Array Flow Pressure Loss and Heat Transfer Characteristics

Experimental and Numerical Study of Convection Heat Transfer of Co2 at Supercritical Pressures in Vertical Porous Tubes

Numerical Analysis of Supercritical CO2 Flow and Heat Transfer Inside Porous Structures on a Microchip

Experimental Investigation on Cooling Heat Transfer and Buoyancy Effect of Supercritical Carbon Dioxide in Horizontal and Vertical Micro-Channels

Experimental Investigation on Convection Heat Transfer of Supercritical CO_2 in Porous Media

Numerical study of supercritical-pressure fluid flows and heat transfer of methane in ribbed cooling tubes

Computational Study of Heat Exchange and Thermal Oxidative Coking of Supercritical-Pressure Kerosene with Compressed Air in Counterflows

Experimental Investigation of Spray Cooling on Micro-, Nano- and Hybrid-Structured Surfaces

Comprehensive evaluation on the thermal-hydraulic performance of supercritical CO2/R41 in a micro-fin tube

Experimental study of CO2 jet field and CO2-MQL-assisted turning of Ti-6Al-4V based on mass flow rate and pressure

Experimental investigation on convection heat transfer of supercritical CO2 in porous media

Experimental Investigation on Heat Transfer and Pressure Drop of Supercritical Carbon Dioxide in a Mini Vertical Upward Flow

Convection heat transfer of supercritical pressure carbon dioxide in a vertical micro tube from transition to turbulent flow regime

Experimental Investigation of Convection Heat Transfer of CO2 at Super-Critical Pressures in Vertical Mini-Tubes and in Porous Media

Numerical Study of CO2 Trans-Critical Process Inside Micromodel Based Porous Structures under Supercritical Pressures

Convection Heat Transfer of Co2 at Supercritical Pressures in A Vertical Mini Tube

EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER OF SUPERCRITICAL CO_2 IN SINTERED POROUS MEDIA