Abstract:This paper presents a new pseudo-3D (P3D) model for a hydraulic fracture growing in a layered rock with contrasts in both material properties and in situ stresses. In the model, the vertically planar fracture is divided along the lateral direction into cells. Within each cell, the cross-sectional deformation is plane strain, and the fluid pressure is allowed to vary vertically. The cells are discretized by displacement discontinuity elements that are formulated to include the elastic layered effect. The fluid flow in the cell is in two directions. Along the central part, which is of uniform pressure, the fluid flow is lateral, corresponding to the main component of fluid transport. Near the vertical fracture edge of a cell, the flow can be vertical and is generated by the vertical pressure gradient. This part of the cell is called the filling part. When the pressure in the filling part reaches the level equal to that in the central part, the flow direction switches from vertical to lateral. The filling and central parts both contribute to fracture height growth. The proposed P3D problem is solved in a coupled manner that accounts for the two-directional flow and cross-sectional deformation through a two-loop iterative method. In the outer loop, the fluid storage of the central part is updated by satisfying mass conservation in the lateral direction, and in the inner loop, the cross-sectional elastic deformation and the influxes to the filling parts are found by satisfying energy minimization subject to an equality constraint on the central-part volume of a cell. The results of pressure ad fracture width at a given elapsed time are thus obtained. After that, fracture growth in both lateral and vertical directions is controlled by the fracture toughness criterion based on linear elasticity. In describing the P3D model, the governing equations are provided and their dimensionless forms are derived. The numerical algorithm used for solving the P3D problem is also described. Numerical examples are presented, including a constant-height fracture, a radial one and asymmetric fractures in three-layered rocks. Comparisons of our results are made with other published results and good agreements between them are found.

A Model for Hydraulic Fracture Growth Across Multiple Elastic Layers

A pseudo-3D model for hydraulic fracture growth in a layered rock

Hydraulic Fracturing Treatment of Low-Permeability Coal Seam Gas Reservoirs with Finely Layered Coals

Predictions of Fracture Growth in Walloon Coals Using a Layer Fracture Model

Numerical Simulation of 3D Hydraulic Fracturing Based on an Improved Flow-Stress-Damage Model and a Parallel FEM Technique

An Analytical and Numerical Analysis for Hydraulic Fracture Propagation through Reservoir Interface in Coal-Measure Superimposed Reservoirs

Numerical simulation study of fracture height growth considering the influence of bedding planes

Numerical Simulation of Crack Initiation and Propagation Evolution Law of Hydraulic Fracturing Holes in Coal Seams Considering Permeability Anisotropy and Damage

Numerical Modeling of Fracture Height Propagation in Multilayer Formations Considering the Plastic Zone and Induced Stress.

Numerical Simulation of Hydraulic Fracture Propagation on Multilayered Formation Using Limited Entry Fracturing Technique

Mechanism of hydraulic fracture vertical propagation in deep shale formation based on elastic–plastic model

Numerical simulation of hydraulic fracture height layer-through propagation based on three-dimensional lattice method

Extended finite element-based cohesive zone method for modeling simultaneous hydraulic fracture height growth in layered reservoirs

DEM Modeling of Simultaneous Propagation of Multiple Hydraulic Fractures Across Different Regimes, from Toughness- to Viscosity-Dominated

Simulation study on the deflection and expansion of hydraulic fractures in coal-rock complexes

The study of hydraulic fracture height growth in coal measure shale strata with complex geologic characteristics

A Dynamic Propagation Numerical Model of Hydraulic Fracture Interactions with Pre-Existing Complex Natural Fractures

A fluid–solid coupling model for hydraulic fracture of deep coal seam based on finite element method

Numerical Simulation of Hydraulic Fracture Propagation in Unconsolidated Sandstone Reservoirs

Fully Coupled Modeling for Multiple Clusters Growth of Hydraulic Fractures in Shale

Investigation of Hydraulic Fracturing Crack Propagation Behavior in Multi-Layered Coal Seams