Abstract:Partial discharge (PD) is a common phenomenon in high voltage (HV) equipment, which will radiate light signals outward in the process of discharge, by detecting this optical signal, we can judge whether the HV equipment have PDs or not, the conventional detection methods under impulse voltage are very complex due to the interference of electromagnetic (EM) wave, but optical method does not have this problem. Fluorescent optical fiber is not affected by numerical aperture problem, so the sensitivity of fluorescent optical fiber sensor is much higher than that of traditional quartz optical fiber sensor. In this work, the fluorescent optical fiber sensor was manufactured and applied to the PD detection in gas insulated switch (GIS) and transformer, fluorescent optical fiber was used as a probe, which was connected with the transmission optical fiber by coupler, and the photomultiplier tube was used to convert the optical signal into electrical signal for displaying by oscilloscope. The discharge signal can be detected by the sensor when the impulse voltage was applied to the GIS and transformer, and it was less affected by the interference of EM wave signals. As the PD source at different positions in GIS, we found that the optical signal attenuates greatly when the optical was blocked by some internal structures, and the attenuation was increase with the increase of distance between PD source and the sensor. The optical signals of PDs can also be detected by the sensor in the transformer, but the attenuation of the optical signal in the transformer was greater than that in GIS, it was greatly affected by the blocking of windings. The two experiments were verified in the TracePro simulation software, and the average deviations between results of experiments and simulations were less than 10%.

PD Characteristics of Non-uniform Electric Field in SF6 Gas under Oscillating Switching Impulse Waveform

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Partial Discharge Characteristics of Uniform Gap in Oil-Impregnated Paper Insulation under Switching Impulse Voltage

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Propogation Characteristics of PD‐induced UHF Signal in 126 Kv GIS with Three‐phase Construction Based on Time–frequency Analysis

Partial Discharge Characteristics of Submillimeter Metal Particles on the Insulator Surface in GIS with Long-time AC Stress

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Detection of Partial Discharge in GIS and Transformer Under Impulse Voltage by Fluorescent Optical Fiber Sensor

Simulation Study on Propagation Characteristics of Optical Signal of Different Partial Discharge Defects

PD Test and Measurement Method of GIS Insulators Based on Cross-reference of the Pulse Current

Time–frequency characteristics of abnormal waveshapes in PD pulse sequence using ultra-wideband detection

Propagation Attenuation Properties of Partial Discharge in Typical In-Field GIS Structures

Study on pulse current of typical PD models in power transformer

Discharge Characteristics and Detectability of Metal Particles on the Spacer Surface in Gas-Insulated Switchgears

The Characteristics and Detection of the Partial Discharge Induced by the Micro Cracks in GIS Insulators

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator