Abstract:Heat exchanger research is mainly exploited to develop and optimize new engineering systems with high thermal efficiency. Passive methods based on nanofluids, fins, wavy walls, and the porous medium are the most attractive ways to achieve this goal. This investigation focuses on heat transfer and entropy production in a nanofluid laminar flow inside a plate corrugated channel (PCC). The channel geometry comprises three sections, partially filled with a porous layer located at the intermediate corrugate channel section. The physical modeling is based on the laminar, two‐dimensional Darcy–Brinkman–Forchheimer formulation for nanofluid flow and the local thermal equilibrium model for the heat equation, including the viscous dissipation term. Numerical solutions were obtained using ANSYS Fluent software based on the finite volume technique and the appropriate meshed geometries. The numerical results are validated with theoretical, numerical, and experimental studies. The simulations are performed for CuO–water nanofluid and AISI 304 porous medium. The coupled effects of porous layer thickness (δ), Reynolds number (Re), and nanoparticle fraction (φ) on velocity, streamlines, isotherm contours, Nusselt number (Nu), and entropy generation (S) are analyzed and illustrated. The simulation results demonstrate that heat transfer enhancement in clear PCC can be achieved using a porous layer insert. For the porous thickness range of [0.1–0.6], the corresponding range of average Nusselt number increase is [35.7%–176.9%], and the average entropy generation is [105.4%–771.9%]. The effect of the Reynolds number is more important in a porous duct than in a clear one. For δ = 0.4 and φ = 5%, the increase of Re in the range of [200–500] induces an increase in average Nusselt number in the range of [80.9%–108.4%] and average entropy in [222.9%–309.1%] comparatively to clear PCC. The effect of φ is practically the same for porous and clear channels. For φ = 5%, the increase on average Nu is about 9%, and entropy generation is 5%. Accordingly, important improvements in heat transfer in PCC can be achieved through the combined effect of flow Reynolds number and porous layer thickness.

Natural Convection and Entropy Generation Analysis Inside a Channel with a Porous Plate Mounted As a Cooling System

Variable Permeability Effects on Natural Convection in a Vertical Porous Layer with Uniform Heat Flux from the Side

Heat transfer analysis of nanofluid flow with entropy generation in a corrugated heat exchanger channel partially filled with porous medium

Numerical investigation of the effect of a porous block and flow injection using non-Newtonian nanofluid on heat transfer and entropy generation in a microchannel with hydrophobic walls

Analysis of Error and Stability of Nanofluid over Horizontal Channel with Heat/Mass Transfer and Nonlinear Thermal Conductivity

Free convection and entropy generation inside porous cavities with irregular vertical walls nonuniformly heated from below

Numerical study on natural convection in a saturated non Darcian porous medium under radiation and entropy generation effects

Investigating the Influence of Square Size Vanes on Heat Transfer in porous media: An In-depth Nusselt distribution

Analytical and Numerical Study on Thermally Developing Forced Convective Flow in a Channel Filled with a Highly Porous Medium Under Local Thermal Non-Equilibrium

Forced Convective Heat Transfer in a Porous Plate Channel

Heat and mass transfer and thermodynamic analysis of power-law fluid flow in a porous microchannel

Computational treatment and thermic case study of entropy resulting from nanofluid flow of convergent/divergent channel by applying the lorentz force

Effects of sinusoidal wall temperature on thermal dynamics and irreversibility around an inclined plate embedded in a square cavity

Natural convection heat transfer and entropy generation in a porous rhombic enclosure: influence of non-uniform heating

Influences of Radiative Heat Transfer on the Entropy Generation Rates of Forced Convection Fluid Flow Between Two Parallel Isothermal Plates Filled with Porous Medium

Effects of Relative Magnetic Field, Chemical Reaction, Heat Generation and Newtonian Heating on Convection Flow of Casson Fluid over a Moving Vertical Plate Embedded in a Porous Medium

The optimum computational simulation of MHD natural convection for improved cooling efficiency and entropy performance inside Ϻ-shaped cabinet

Investigating double-diffusive natural convection in a sloped dual-layered homogenous porous-fluid square cavity

Thermal and Entropic analyses of free convection of nanofluid in a partially heterogeneous porous chamber using the two-phase mixture model

Magnetohydrodynamic forced convection in bidisperse porous medium: Analysis of flow and temperature distributions in a parallel‐plate channel

MHD mixed convection and entropy generation of CNT-water nanofluid in a wavy lid-driven porous enclosure at different boundary conditions