Abstract:This paper investigates mechanisms of the surface charge dissipation of silicone rubber (SiR) after dielectric barrier discharge (DBD) plasma treatments in an open air. Electrical and physicochemical properties of the untreated and plasma treated samples were evaluated by surface and volume conductivity, surface potential decay (SPD) measurements, Fourier transform infrared (FT-IR), and water contact angle tests. Results show that the surface conductivity of the plasma treated samples evidently increases with the treatment time. The samples with a longer DBD plasma treatment time enhance the SPD rate after the positive and negative corona charging. However, an abnormal surface potential variation is observed at the beginning of the SPD after the negative corona charging. It is found that the top-bottom surface plasma treatment can further accelerate the SPD of the samples compared with the untreated and single surface plasma treated samples. The physicochemical analysis shows that the concentration of polar groups is increased after the plasma treatment, and the water contact angle is consistently declined with the increase of the plasma treatment time. The calculated trap distribution illustrates that the hole trap energy and the electron trap density of the sample are decreased after the plasma treatments. This investigation attributes the measured SPD of the untreated sample and single surface treated samples to the electrical conduction along the sample surface, but the SPD of the top-bottom surfaces plasma treated samples is enhanced by the charge neutralization and transportation through the material bulk as well as the sample top surface conduction.

Characterization of surface dielectric barrier discharge (SDBD) based on PI/Al2O3 nanocomposite

Experimental Investigation of Surface Dielectric Barrier Discharge Plasma Actuator Based on Fluorinated Polyimide

PI/Al2O3 nanocomposite based long lifetime surface dielectric barrier discharge plasma actuator

Influence of DBD Treated Nano‐al2o3 on Thermal and Electrical Insulation Properties of Epoxy Nanocomposites at High Temperatures

Enduring And Stable Surface Dielectric Barrier Discharge (Sdbd) Plasma Using Fluorinated Multi-Layered Polyimide

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Comparison Between Aln and Al2o3 Ceramics Applied to Barrier Dielectric of Plasma Actuator

Electromechanical Efficiency Improvement of the Surface DBD by Composite Dielectric

Surface Conductivity Effects of SDBD Plasma Actuators Before Discharge Established

Surface charge dissipation and DC flashover characteristic of DBD plasma treated epoxy resin/AlN nanocomposites

Effects of Material Degradation on Electrical and Optical Characteristics of Surface Dielectric Barrier Discharge

Electrical and Optical Characteristics of the Radio Frequency Surface Dielectric Barrier Discharge Plasma Actuation

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Modelling Of Plasma Aerodynamic Actuation Driven By Nanosecond Sdbd Discharge

Surface Potential Decay and DC Surface Flashover Characteristics of DBD Plasma-Treated Silicone Rubber

Characteristics of annular surface dielectric barrier discharge with microsecond pulse under water-covered condition

Parametric Study on the Characteristics of a SDBD Actuator with a Serrated Electrode

Characteristics of Unipolar Nanosecond Pulse DBD andIts Application on Surface Treatment of Polyimer Films

Three-electrode surface dielectric barrier discharge driven by repetitive pulses: streamer dynamic evolution and discharge mode transition

Surface Modification of Polyimide Films Using Unipolar Nanosecond-Pulse DBD in Atmospheric Air

Characteristics of Nanosecond Pulse Surface Dielectric Barrier Discharge in Air Flow