Abstract:Calcareous sand has been used as the main filling material in numerous reef constructions. Therefore, understanding its long-term dynamic engineering geological characteristics under cyclic applications of traffic or wave loading is crucial to the design and prediction of the serviceability of reef infrastructures. Considering this, seven monotonic triaxial tests and 33 high-cycle (25,000 cycles) drained triaxial tests were conducted on calcareous sand with various mean effective stresses (p') and cyclic stress ratios (ζ). The results show that the development of the accumulated axial strain (ε1acc) has a strong correlation with the positional relationship between the cyclic stress path and critical strength line (CSL) or static strength envelope (SSE) in the p'-q plane. The critical cyclic stress ratio ζc, that represents the cyclic stress path reaching the CSL, is proposed. When ζ>ζc, the growth rate of ε1acc with ζ increases drastically. Moreover, when the cyclic stress path approaches the SSE, ε1acc enters an incremental collapse state. The increase in p' diminishes the dilatancy of the volumetric strain εv. However, this response of εv reverses from decreasing to increasing with increasing ζ. The resilient modulus (Mr) increases with the number of cycles (N) due to the initial densification. If εv dilation occurs, Mr will decrease with N as particles lose contact. A single parameter for the cyclic stress path ratio (ψ) considering the effects of p', ζ, and SSE is proposed. Additionally, empirical formulas for calculating the ultimate ε1acc and Mr are established. Furthermore, particle degradation significantly worsens ε1acc and εv, but has a more profound effect on the compressibility of εv. This degradation is also detrimental to Mr. A certain deviation trend of the predicted values from the measured values is found to correspond with the relative particle breakage.

Monotonic and cyclic behaviors of loose anisotropically consolidated calcareous sand in torsional shear tests

Cyclic Flow Behavior of Anisotropically Consolidated Sand with a Small Amount of Fines

Energy-Based Approach to Quantify Cyclic Resistance and Pore Pressure Generation in Anisotropically Consolidated Sand

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Undrained Behavior of Sand under Cyclic Paths That Match Storm-Wave Loading Conditions

Energy-based Assessment of Cyclic Liquefaction Behavior of Clean and Silty Sand under Sustained Initial Stress Conditions

Liquefaction resistance of anisotropically consolidated sand under monotonic and cyclic undrained torsional shear

The monotonic and cyclic shear characteristics of saturated marine coral sand under various anisotropic features

Unified Modeling of the Influence of Consolidation Conditions on Monotonic Soil Response Considering Fabric Evolution

Development of pore water pressure in anisotropically consolidated sand under cyclic torsional loading

Cyclic Behavior of Calcareous Sand from the South China Sea

Undrained cyclic behaviors of fiber-reinforced calcareous sand under multidirectional simple shear stress path

Long-term behaviour and degradation of calcareous sand under cyclic loading

Effect of Initial Consolidation Stress Path on Shear Behavior of Calcareous Sand

Monotonic and Cyclic Characteristics of K0-Consolidated Saturated Soft Clay under a Stress Path Involving a Variable Confining Pressure

Effect of Drained Static Shear on Cyclic Deformation Behavior of K-0-consolidated Sand

Fixed-axis shear characteristics of marine coral sand under various consolidation conditions

Effects of consolidation conditions on the dynamic shear modulus of saturated coral sand over a wide strain range

Liquefaction of Sand under Monotonic and Cyclic Shear Conditions: Impact of Drained Preloading History

Stress–dilatancy behavior of dense marine calcareous sand under high-cycle loading: An experimental investigation