Abstract:To explore the distinction between generation atmosphere of fuel NOx and thermal NOx in an ammonia-hydrogen compound fuel engine, a numerical calculation model was established based on a detailed ammonia-hydrogen oxidation mechanism. The combustion process and NOx evolution mechanism of the ammonia-hydrogen compound fuel engine under different intake conditions were studied. The research results for different equivalence ratios show that the in-cylinder hydrogen volume is the primary factor influencing the initial heat release. When the equivalence ratio is between 0.89 and 1.14, the mixture exhibits a higher combustion rate, leading to a shorter CD and an earlier CA50. At this point, the heat release process closer to TDC contributes improving engine combustion efficiency and indicated efficiency. Therefore, when the equivalence ratio is between 0.89 and 1.00, combustion efficiency is higher than 98% and indicated efficiency is higher than 43%, the ammonia-hydrogen compound fuel engine achieves relatively higher economy. Both over-rich and over-dilute mixtures induce an enhancement of fuel NOx, while the higher in-cylinder temperature caused by stoichiometric combustion leads to a boom of thermal NOx. Consequently, the total NOx emission from the ammonia-hydrogen compound fuel engine is higher at equivalence ratios between 0.80 and 1.00, and the NOx emission reaches its peak at an equivalence ratio of 0.89. Analysis of the evolution process of key N components in the cylinder shows that incomplete combustion plays a significant role in fuel NOx emissions, while thermal NOx emissions are mainly influenced by the distribution of in-cylinder components and combustion temperature. Specifically, thermal NOx emissions primarily depend on the in-cylinder components distribution in the narrow equivalence ratio range around stoichiometric ratio, and are significantly affected by in-cylinder temperature under other conditions. The in-cylinder oxygen concentration significantly affects fuel NOx emissions under most operating conditions. Further optimization of intake temperature shows that combustion efficiency exceeds 90% when the intake temperature is above 280 K. When the intake temperature reaches 310 K, the combustion efficiency reaches up to 98%, thus an intake temperature of about 310 K is sufficient to meet the need for improving the combustion efficiency of ammonia-hydrogen compound fuel engine. To achieve high efficiency and lower NOx emissions, appropriate lean combustion combined with an intake temperature slightly above room temperature is recommended.

Calculating Of Aircraft Engine Emissions In Cruise Phase

Design of Transition State Control Method for Civil Aviation Engine Facing NOx Emission Reduction Target

Combustion Simulation with Particular Reference to Green Aviation

Performance seeking control method for minimum pollutant emission mode for turbofan engine

An evaluation method of particulate matter emission performance for CJ1000A aeroengine

Application of CFD, Taguchi Method, and ANOVA Technique to Optimize Combustion and Emissions in a Light Duty Diesel Engine

Numerical Investigation into the Characteristics of Fuel-Borne Nitrogen Pollutants in Ammonia-Diesel Dual Fuel Engines Through Implementing Atmospheric Nitrogen Unreactivity

Assessment of predicted aircraft engine non-volatile particulate matter emissions at Hangzhou Xiaoshan International Airport using an integrated method

Diesel Engine Emissions Simulation and Test in Working Process

Modeling Civil Aviation Emissions with Actual Flight Trajectories and Enhanced Aircraft Performance Model

Prediction of aircraft engine emissions using ADS-B flight data

Multi-Objective Optimization and Chemical Reactor Network Modelling to Estimate the Minimum NOx and Ammonia Slip in an Aviation Combustor

Numerical Simulation and Experiment for Soot and NOx Emission in Diesel Engine

Numerical Modeling of Diesel Engine Combustion and Emissions Under HCCI-Like Conditions With High EGR Levels

Numerical study of the combustion process and NOx evolution mechanism of ammonia-hydrogen compound fuel engine under different intake conditions

Comparative study of the NOx prediction model of HCNG engine

Emission Evaluation for Diesel Vehicles Under Typical Operating Conditions

Modelling of Aircraft Non-CO2 Emissions Using Freely Available Activity Data from Flight Tracking

Experimental and Numerical Study of the Pollution Formation in a Diesel/cng Dual Fuel Engine

Uncertainty and its driving factors of airport aircraft pollutant emissions assessment

Analysis of Marine Diesel Engine Emission Characteristics of Different Power Ranges in China