Abstract:Nitrogen doping has been always regarded as one of the major factors responsible for the increased catalytic activity of Fe–N–C catalysts in the oxygen reduction reaction, and recently, sulfur has emerged as a co-doping element capable of increasing the catalytic activity even more because of electronic effects, which modify the d-band center of the Fe–N–C catalysts or because of its capability to increase the Fe–Nx site density (SD). Herein, we investigate in detail the effect of sulfur doping of carbon support on the Fe–Nx site formation and on the textural properties (micro- and mesopore surface area and volume) in the resulting Fe–N–C catalysts. The Fe–N–C catalysts were prepared from mesoporous carbon with tunable sulfur doping (0–16 wt %), which was achieved by the modulation of the relative amount of sucrose/dibenzothiophene precursors. The carbon with the highest sulfur content was also activated through steam treatment at 800 °C for different durations, which allowed us to modulate the carbon pore volume and surface area (1296–1726 m2 g–1). The resulting catalysts were tested in O2-saturated 0.5 M H2SO4 electrolyte, and the site density (SD) was determined using the NO-stripping technique. Here, we demonstrate that sulfur doping has a porogenic effect increasing the microporosity of the carbon support, and it also facilitates the nitrogen fixation on the carbon support as well as the formation of Fe–Nx sites. It was found that the Fe–N–C catalytic activity [E1/2 ranges between 0.609 and 0.731 V vs reversible hydrogen electrode (RHE)] does not directly depend on sulfur content, but rather on the microporous surface and therefore any electronic effect appears not to be determinant as confirmed by X-ray photoemission spectroscopy (XPS). The graph reporting Fe–Nx SD versus sulfur content assumes a volcano-like shape, where the maximum value is obtained for a sulfur/iron ratio close to 18, i.e., a too high or too low sulfur doping has a detrimental effect on Fe–Nx formation. However, it was highlighted that the increase of Fe–Nx SD is a necessary but not sufficient condition for increasing the catalytic activity of the material, unless the textural properties are also optimized, i.e., there must be an optimized hierarchical porosity that facilitates the mass transport to the active sites.This article has not yet been cited by other publications.

Experimental Boosting of the Oxygen Reduction Activity of an Fe/N/C Catalyst by Sulfur Doping and Density Functional Theory Calculations

Regulating the Electronic Configuration of Single-Atom Catalysts with Fe-N5 Sites Via Environmental Sulfur Atom Doping for an Enhanced Oxygen Reduction Reaction

Boosting the Activity of Fe-Nx Moieties in Fe-N-C Electrocatalysts Via Phosphorus Doping for Oxygen Reduction Reaction

Unraveling the Origin of Sulfur‐Doped Fe‐N‐C Single‐Atom Catalyst for Enhanced Oxygen Reduction Activity: Effect of Iron Spin‐State Tuning

Iron Nanoparticles Encapsulated in S,N-Codoped Carbon: Sulfur Doping Enriches Surface Electron Density and Enhances Electrocatalytic Activity Toward Oxygen Reduction.

Synergistic Effects between Atomically Dispersed Fe−N−C and C−S−C for the Oxygen Reduction Reaction in Acidic Media

A Versatile Approach to Boost Oxygen Reduction of Fe‐N 4 Sites by Controllably Incorporating Sulfur Functionality

Large Specific Surface Area S-doped Fe–N–C Electrocatalysts Derived from Metal–Organic Frameworks for Oxygen Reduction Reaction

Rational Design of a Fe/S/N/C Catalyst from ZIF-8 for Efficient Oxygen Reduction Reaction

O-Doping Boosts the Electrochemical Oxygen Reduction Activity of a Single Fe Site in Hydrophilic Carbon with Deep Mesopores

Fe Isolated Single Atoms on S, N Codoped Carbon by Copolymer Pyrolysis Strategy for Highly Efficient Oxygen Reduction Reaction

Synergistic Effect between the Atomically Dispersed Active Site of Fe-N-C and C-S-C for ORR in Acidic Medium.

An Fe-N/S-C hybrid electrocatalyst derived from bimetal-organic framework for efficiently electrocatalyzing oxygen reduction reaction in acidic media

Using a Fe-doping MOFs Strategy to Effectively Improve the Electrochemical Activity of N-doped C Materials for Oxygen Reduction Reaction in Alkaline Medium

S-doped M-N-C catalysts for the oxygen reduction reaction: Synthetic strategies, characterization, and mechanism

Study on oxygen reduction mechanism of S-doped Fe-NC monatomic catalyst

S heteroatom doping in highly porous carbonaceous spheres for boosted oxygen reduction reaction of atomically dispersed Fe–N4 active sites

Enhanced Fe Dispersion Via “pinning” Effect of Thiocyanate Ion on Ferric Ion in Fe-N-S-doped Catalyst As an Excellent Oxygen Reduction Reaction Electrode

On the role of Zn and Fe doping in nitrogen-carbon electrocatalysts for oxygen reduction

Sulfur Doping versus Hierarchical Pore Structure: The Dominating Effect on the Fe–N–C Site Density, Activity, and Selectivity in Oxygen Reduction Reaction Electrocatalysis

Mechanism insights into CO oxidation on a low-cost N doped pyrite: A molecular simulation study