Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Modeling And Temperature Distribution Estimation Based On Kalman Filter Algorithm Of A Planar Solid Oxide Fuel Cell

Estimation of Spatial Temperature Distribution in Co-Flow Planar Solid Oxide Fuel Cells

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

A Predictive Model Of Solid Oxide Fuel Cell Stacks For Thermal Mangement

Machine Learning Based Soft Sensor and Long-Term Calibration Scheme: A Solid Oxide Fuel Cell System Case

Experimental investigation of temperature distribution in solid oxide fuel cells

A Reduced-Order Electrochemical Model for Analyzing Temperature Distributions in a Tubular Solid Oxide Fuel Cell Stack

A New Method of Improved Generalized Predictive Control for Solid Oxide Fuel Cell's Temperature System

Modeling of SOFC System Reduction and Simulation Testing

Afterburner temperature safety assessment for solid oxide fuel cell system based on computational fluid dynamics

System Modeling and Temperature Control for a Fuel Cell System Based on Local Model Networks

Investigation of Thermal Radiation Effects on Solid Oxide Fuel Cell Performance by A Comprehensive Model

Control Loop Design and Control Performance Study on Direct Internal Reforming Solid Oxide Fuel Cell

Nonlinear Observation of Internal States of Fuel Cell Cathode Utilizing A High-Order Sliding-Mode Algorithm

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Thermal Management Subsystem Model and Temperature Control for Fuel Cells

Structure optimization and thermal field analysis of biogas derived methane fueled Solid Oxide Fuel Cell

Multiphysics Simulation of a Solid Oxide Fuel Cell Based on COMSOL Method

An Analytical Model of View Factors for Radiation Heat Transfer in Planar and Tubular Solid Oxide Fuel Cells

Model-Based Temperature Tracking Control in Automotive Fuel Cells