Abstract:This paper presents the implementation and experimental evaluation of a short-packet physical-layer network coding (PNC) system. Implementation of short-packet PNC systems is challenging. First, short packets may have only a few pilot symbols for synchronization and channel estimation purposes. Increasing the number of pilots increases the overhead; decreasing the number of pilots, on the other hand, degrades the packet error rate performance. Second, many short-packet systems are meant for applications with very stringent delay requirements. Employing advanced but complex PNC channel decoding may result in unacceptable delay due to the processing delay. This work presents a low-complexity and low-overhead physical-layer design of OFDM-based short-packet PNC systems, implemented over the software-defined radio platform. Our design makes use of only a small number of pilots (without separate OFDM preamble symbols) to address issues such as slot synchronization, packet detection, carrier frequency offsets, and mismatched channel state information. Our design employs reduced-complexity XOR channel decoding based code-aided parameter estimation (that includes synchronization and channel estimation) to compensate for the limitations imposed by having a small number of pilots. This is the first demonstration that provides a practical framework for applying PNC to short-packet communications.

Design of the Critical Controller in Physical Coding Sublayer Based on the 10Gbase-Kr Protocol

Design of the Physical Coding Sublayer Based on the Ethernet 10Gbase-R Protocol

Design and Implementation of Coding Algorithm in Physical Coding Sublayer of Gigabit Ethernet

Design and protocol analyzer verification of the physical coding sublayer based on the FC protocol

Research on 10 Gigabit Ethernet Physical Layer Converter

Design of Electronics for Phase Coding QKD System

Design of an In-line Packet Transceiver for 10 Gb/s Ethernet

A Single-Routing Layered LDPC Decoder for 10Gbase-T Ethernet in 130nm CMOS

Design and Implementation of the Physical Layer Control System Based on TD-LTE Baseband Chip

Design of A Packet-Based Control Framework for Networked Control Systems

DESIGN AND IMPLEMENTATION OF NETWORK CODING BASED SWITCHING SYSTEM SIMULATION PLATFORM

Design and implementation of multi-mode QC-LDPC decoder

Optimization of QDR SRAM Controller in Network Processor

Physical-layer Network Coding: A High Performance PHY-layer Decoder

Analysis Of A Qos-Based Parallel Packet Switch For Core Routers

A Gigabit, DMA-enhanced Open-Source Ethernet Controller for Mixed-Criticality Systems

Design of JESD204B Transmitter Interface Using Parallel 8b/10b Encoder

Design On Polarization Weight-Based Polar Coded Scma System Over Fading Channels

Design of a Hybrid Switching Architecture for Avionic WDM Platforms

A collection of the data coding means and event coding means multiplexed over the 1000BASE-T1, 10GBASE-T, 10GBASE-KR, MultiGBASE-T1, 25G/40GBASE-T, 2.5G/5GBASE-T, 100GBASE-R, 10G/25G-EPON, and 10GPASS-XR microframes

Implementation of Short-Packet Physical-Layer Network Coding