Abstract:As wind turbines become larger and move into deeper sea, their operating environment worsen. The torque fluctuation inside the drive chain is aggravated, which leads to the premature failure of the wind turbines. To improve the transmission stability of wind turbines, the mechanical-hydraulic hybrid transmission system (MHHTS) has been applied. However, existing research has issues with structure and hydraulic control. An MHHTS structure was proposed to meet the requirements of structural simplicity and high efficiency, corresponding to the design principles summarized in the article. Based on this structure, we have selected a hydraulic control mode, the constant displacement pump variable displacement motor (CPVM), that satisfies the reasonable utilization of displacement and the stability of control. This mode was chosen by comparing the displacement and pressure variation rules of three hydraulic control modes that meet the maximum power point tracking (MPPT) control principle of the wind turbine. In this study a co-simulation model of a 10 MW MHHTS wind turbine was built using Simulink and AMEsim. The correctness of the structural and control mode ware verified by co-simulation with a uniformly varying wind. Moreover, a method that can suppress fluctuations in output power by controlling the motor displacement was proposed. Different-step winds response analyses were conducted to explore the relationship between the displacement response speed and the output power fluctuations. The non-linear relationship between the displacement and the wind speed can also have an impact on the previous relationship. Finally, the feasibility of the control method was verified through simulation of an actual turbulent wind. These achievements should guarantee the future application of the novel transmission system in wind turbines.

Robust Speed Tracking Control for a Micro Turbine as a Distributed Energy Resource via Feedback Domination and Disturbance Observer

Exact Speed Tracking Realization of the Single Shaft Micro-Turbine System Via Higher-Order Sliding Mode Observer

Model Predictive Control of a Solar Power System with Microturbine and Thermochemical Energy Storage

Adaptive Dual-layer Sliding Mode Control for Wind Turbines with Estimated Wind Speed

Adaptive Continuous Neural Pitch Angle Control for Variable‐Speed Wind Turbines

Bounded UDE Based MPPT Control for Wind Turbines

Adaptive power acquisition control of variable-speed wind energy conversion systems under inaccurate wind speed measurement

Design and Control of the Mechanical-Hydraulic Hybrid Transmission System in Wind Turbines

SVD-Based Robust Distributed MPC for Tracking Systems Coupled in Dynamics with Global Constraints

Robust Speed Control Methodology for Variable Speed Wind Turbines

Design, Modeling and Implementation of a Novel Pitch Angle Control System for Wind Turbine

An Improved Optimal Torque Control Based on Estimated Wind Speed for Wind Turbines

Optimal Power Tracking Control of a Hydraulic Wind Turbine Based on Active Disturbance Rejection Control Methodology

Design of Disturbance Extended State Observer (D-ESO)-Based Constrained Full-State Model Predictive Controller for the Integrated Turbo-Shaft Engine/Rotor System

Auto Disturbance Rejection Control Strategy of Wind Turbine Permanent Magnet Direct Drive Individual Variable Pitch System Under Load Excitation

Non-Singular Fast Terminal Sliding Mode and Adaptive Robust Method

Independent Pitch Adaptive Control of Large Wind Turbines Using State Feedback and Disturbance Accommodating Control

Adaptive Power Tracking Control Based on Dynamic Sensor Estimation for Energy Conversion Systems

Decentralized Active Disturbance Rejection Control Design for the Gas Turbine

Wind Turbine Control Strategy Based on Robust Model Predictive Control

Model-free control for variable-speed wind energy conversion systems based on power tracking