Targeted Cell Membrane Damage by Bipolar High Repeated Frequency Pulses

Chenguo Yao,Yanpeng Lv,Lingyu Gong,Shoulong Dong,Yajun Zhao,Liling Tang,Xiaoyu Wang,Ying Chen

DOI: https://doi.org/10.1109/tdei.2017.006306

IF: 2.509

2017-01-01

IEEE Transactions on Dielectrics and Electrical Insulation

Abstract:Irreversible electroporation (IRE) uses high-intensity electric pulses of similar to 100 mu s duration to induce cell death through permanent membrane destruction. In this study, monopolar pulses are replaced by bipolar high repeated frequency pulses (BHRFPs) while maintaining a constant total energized time (100 mu s), burst number (90), and inter-burst delay (1 s). To observe the damage to the cell membrane directly, the fluorescent dye DiI, which has the advantages of a high signal-to-noise ratio, a lack of toxicity in cells, and slow fading, is used to label the cell membrane. This study explores the degree of damage to the stained adherent cell membrane caused by BHRFPs with equal quantities of energy. The experimental results show that the degree of damage to the cell membrane gradually increases with increasing number of bursts, but different changes are observed with different pulse widths. The DiI fluorescence intensity (degree of damage to the cell membrane) decreases from 79% to 54% with an increase in the pulse width from 400 ns (250 x) to 10 mu s (10 x). Therefore, a positive relationship exists between the degree of cell membrane damage as we increase the pulse duration from 400 ns (250 pulses) to 10 mu s (10 pulses) at the same electric field strength while delivering the same total energy. The amount of cell membrane damage increases for increasing electric field strengths with sufficiently strong fields ultimately inducing cell lysis. A numerical model of single cell is built to investigate the mechanism considering the effect of electroporation. The simulated results also show that the total pore area increases by applying the electric pulse with a pulse width of 400 ns (250 x) to 10 mu s (10 x); an increase in the total pore area means a stronger damage degree, which agrees well with the experimental results.