Abstract:Fabricating nanofiltration membranes with high water permeance and selectivity by tailoring the structure and morphology is crucial to efficient water purification. In this work, the fabrication of thin film nanocomposite (TFN) nanofiltration membranes by combining two methods, the surfactant-assembly interfacial polymerization (SARIP) and the addition of graphene oxide (GO) or ionic liquid functionalized graphene oxide (GO-IL) for the preparation of the selective PA layer on a novel porous substrate is reported. For the preparation of the porous substrate, mechanically robust, aromatic polyethers containing polar pyridine units (PDSPP) were chosen targeting to improved hydrophilicity and thus enhanced water permeability. The anionic sodium dodecyl sulfate (SDS) surfactant was used to regulate the interfacial polymerization thereby enabling the formation of dense PA layers with high cross-linking degree and consequently high salt rejections. On the other hand, the addition of GO/GO-IL nanosheets could impart hydrophilicity and antifouling properties. The novel porous PDSPP substrate was selected for the fabrication of TFN membranes due to its improved water permeability and superior salt rejection and increased hydrophilicity compared to commercial PSf substrate. The detailed study of the fabricated TFN membranes by ATR-FT-IR, SEM, AFM, XPS, contact angle measurements revealed the formation of polyamide selective layers with rougher surfaces, increased hydrophilicity and high cross-linking degrees (from 44 % to 94 %), resulted from the synergistic effect of SDS and GO incorporation. Moreover, the prepared TFN membranes exhibited high salt rejections while maintaining a moderate water permeability. In particular, the membrane containing the neat GO (TFNGO50) displayed excellent Na 2 SO 4 and MgSO 4 rejections (98.8 % and 99.5 %, respectively) while the NaCl rejection was 47.0 % and a water permeability value of 4.2 L m -2 h −1 bar −1 . The divalent salt rejections were among the highest values reported in the literature in comparison with commercial NF membranes and TFN membranes containing GO/functionalized GO. When GO-IL nanosheets were embedded in the PA layer, the water permeability was slightly improved while the salt rejections were significantly reduced compared to TFNGO50. Lastly, the incorporation of GO enhanced the anti-fouling properties of the prepared membranes due to increased hydrophilicity of the PA surface.

Graphene oxide-embedded polyamide nanofiltration membranes for selective ion separation

Graphene Oxide Based Membrane Intercalated by Nanoparticles for High Performance Nanofiltration Application

Carboxyl-functionalized graphene oxide polyamide nanofiltration membrane for desalination of dye solutions containing monovalent salt

“Mix-Then-On-Demand-Complex”: In Situ Cascade Anionization and Complexation of Graphene Oxide for High-Performance Nanofiltration Membranes

Functionalised graphene oxide-based nanofiltration membranes with enhanced molecular separation performance

Graphene Oxide-in-polymer Nanofiltration Membranes with Enhanced Permeability by Interfacial Polymerization

Graphene Oxide Polypiperazine-Amide Nanofiltration Membrane for Improving Flux and Anti-Fouling in Water Purification

High-permeable graphene oxide/graphitic carbon nitride composite nanofiltration membrane for selective separation of dye and desalination

Graphene Oxide Interlayered Thin-Film Nanocomposite Hollow Fiber Nanofiltration Membranes with Enhanced Aqueous Electrolyte Separation Performance

Graphene Oxide-Based Membranes Intercalated with an Aromatic Crosslinker for Low-Pressure Nanofiltration

GO and surfactant assisted regulation of polyamide nanofiltration membranes for improved separation performance

Fabrication of ultra-smooth thin-film composite nanofiltration membrane with enhanced selectivity and permeability on interlayer of hybrid polyvinyl alcohol and graphene oxide

Regulating the surface properties and interlamellar spacing of GO-based nanofiltration membrane for efficient water treatment

A High Stability GO Nanofiltration Membrane Preparation by Co-Deposition and Crosslinking Polydopamine for Rejecting Dyes.

“Bridge” Graphene Oxide Modified Positive Charged Nanofiltration Thin Membrane with High Efficiency for Mg2+/Li+ Separation

Membranes with selective laminar nanochannels of modified reduced graphene oxide for water purification

Fabrication of Ph-Sensitive Thin-Film Nanocomposite Nanofiltration Membranes with Enhanced Performance by Incorporating Amine-Functionalized Graphene Oxide

Graphene Oxide Nanofiltration Membranes with Confined Na+ in Two-Dimensional Nanochannels

Chemically Cross-Linked Graphene Oxide as a Selective Layer on Electrospun Polyvinyl Alcohol Nanofiber Membrane for Nanofiltration Application

Spin-assisted interfacial polymerization strategy for graphene oxide-polyamide composite nanofiltration membrane with high performance

Preparation of Graphene Oxide Modified Poly(m-Phenylene Isophthalamide) Nanofiltration Membrane with Improved Water Flux and Antifouling Property