Abstract:Modeling the behavior of suspended particles in gaseous phase is important for diverse reasons; e.g. aerosol is usually the main subject of CFD simulations in clean rooms. Additionally, to determine the rate and sites of deposition of particles suspended in inhaled air, the motion of the particles should be predicted in lung airways. Meanwhile there are two basically different approaches to simulate the behavior of particles suspension, Lagrangian and Eulerian approaches. This study compares the results of these two approaches on simulating the same problem. An in-house particle tracking code was developed to simulate the motion of particles with Lagrangian approach. In order to simulate the same problem with Eulerian approach, the solution to the transport equation with appropriate initial and boundary conditions was used. In the first case study, diffusion of particles, initially positioned homogeneously on an infinite plane was modeled with both approaches and the results were compared and the mismatch between Lagrangian and Eulerian approaches was analyzed for different concentrations. In the second case study, airflow with parabolic velocity profile moving between two parallel plates was modeled with two approaches. The airflow initially contained a homogeneous suspension of particles and the plates were maintained at zero concentration. The concentration along the plates was compared between the two approaches and the differences in the performance of each approach were investigated, again for different initial concentrations. The overall results confirm that as particle concentration falls below a minimum amount, approximately 105 m−2, the results of the two approaches deviate considerably from each other and hence the Eulerian approach cannot be taken as an alternative for Lagrangian approach for low concentrations. For the third problem, we investigated the 3D particle flow in an expanding lung alveolus. It is shown that when the number of total released particles increases, the results of Eulerian approach can be used as an alternative to Lagrangian simulation. Since the number of particles existing in the lung alveolus in normal condition is much lower than this value, we concluded that Eulerian method cannot be applied to problems involving low concentration of particles. Although, the results of the Lagrangian problem may converge to the Eulerian one by increasing simulation time, but it is a hypothetical situation which not really exist in short time scale problems such as third case study in this paper.

CFD Simulation of Cooking Particle Distribution and Motion

Cooking generated particles’ impact on indoor air quality of university cafeteria

Investigations for Reducing Personal Exposure to PM2.5 from Residential Chinese Cooking Based on CFD Simulation

Advances in Cryogenic Engineering: Volumes 35A and B

Control of temperature and fume generation by cooking in a residential kitchen by ceiling radiative cooling and fume hood extraction

Determination of Size-Dependent Source Emission Rate of Cooking-Generated Aerosol Particles at the Oil-Heating Stage in an Experimental Kitchen

Numerical evaluation of the air quality and thermal comfort in the cooking kitchen under exhausting effects of the range hood

Influence of Cooking Pollutant Diffusion Regularity by High-Rise Residential Inner-Courtyard Forms in Wuhan

Simulation of indoor cigarette smoke particles in a ventilated room

Experimental Study of Relative Exposure to Particles Transmitted from Kitchen in an Apartment

A novel approach for large-scale characterization of residential cooking-generated PM with computer vision and low-cost sensors

Numerical Study of the Effect of Ventilation Pattern on Coarse, Fine, and Very Fine Particulate Matter Removal in Partitioned Indoor Environment

Emission and capture characteristics of Chinese cooking-related fine particles

Spatial Distributions of Particle Number Size Distributions Generated During Cooking Processes and the Impacts of Range Hoods

Numerical simulation of particulate matter propagation in an indoor environment with various types of heating

CFD-DEM Simulation of Heat Transfer in Fluidized Beds: Model Verification, Validation, and Application

Effects of chef operation on oil fume particle collection of household range hood

Molecular composition and gas-particle partitioning of indoor cooking aerosol: Insights from a FIGAERO-CIMS and kinetic aerosol modeling

CFD boundary conditions for contaminant dispersion, heat transfer and airflow simulations around human occupants in indoor environments

Indoor Distribution and Personal Exposure of Cooking-Generated PM2.5 in Rural Residences of China: A Multizone Model Study

Technical note: Dispersion of cooking-generated aerosols from an urban street canyon