Abstract:A servo system of automatic loading manipulator arm (ALMA) with backlash nonlinearity is investigated in this paper to suppress the limit cycle oscillation. To provide a more accurate representation of the system response, a two-inertia model method is employed. According to the system response, the influence of variation in backlash width, load inertia, and proportionality factor on the limit cycle is discussed using the frequency domain analysis method. The decrease in transmission torque resulting from backlash nonlinearity as the main cause of limit cycle oscillation is identified. Based on frequency domain analysis, an oscillation suppression method that employs backlash as disturbance compensation is proposed. A novel Third-order Nonlinear Extended State Observer (TNESO) that is more economical and reliable than torque sensors is utilized to estimate the transmission torque. Consequently, the estimated transmission torque as well as the displacement of the motor and load is utilized to obtain the backlash disturbance which can be counteracted by introducing a compensation of current reference value to mitigate the adverse effects of backlash on the system. The comparison of displacement-time curve between compensated and uncompensated experiments reveals that positioning error is reduced from 0.006 to 0.001 rad when displacement is compensated. Besides, the compensated system's position curve is smoother. Thus, the effectiveness of the proposed method is verified.

Suppression of Limit Cycle Oscillation for Two-Mass System with Backlash Nonlinearity Based on Dual Luenberger Observer

Analysis and Suppression of Limit Cycle Oscillation for Transmission System with Backlash Nonlinearity

Analysis Of Limit Cycle Mechanism For Two-Mass System With Backlash Nonlinearity

Suppression of Mechanical Resonance Using Torque Disturbance Observer for Two-Inertia System with Backlash

Backlash compensation based oscillation suppression control for automatic loading manipulator arm with nonlinear extended state observer

Nonlinear Motion Control of a Hydraulic Press Based on an Extended Disturbance Observer

EXTENDED DISTURBANCE OBSERVER-BASED SLIDING MODE FAULT-TOLERANT CONTROL FOR THE DUAL-VALVE HYDRAULIC SERVO SYSTEM WITH REDUCED-ORDER MODEL

Backstepping Control Collaborative Shaft Torque Observer for Limit Cycle Oscillation Suppression of Fully Closed-Loop Gear Transmission Servo System

A Position Control Based on Active Disturbance Rejection Controller Considering Parameter Variations of Harmonic Drive Gear Systems

Dual-drive Anti-Backlash System Based on Torque Compensation

Mechanical Resonance Suppression And Disturbance Rejection Of 2-Inertia System With Observer-Based Feedback Control

Design of a Low-Order Harmonic Disturbance Observer with Application to a DC Motor Position Control

A disturbance-observer-based feedforward-feedback control strategy for driveline launch oscillation of hybrid electric vehicles considering nonlinear backlash

Backlash Identification in Two-Mass Systems by Delayed Relay Feedback

Modeling and limit cycle analysis for systems with backlash

Design and Application of State Observer for Two-mass Torsional System

Mechanical Resonance Suppression and Disturbance Rejection of Two-Mass System Based on State-Feedback Observer

Backstepping Sliding Mode Control for Robot Manipulator Via Nonlinear Disturbance Observer

Disturbance observer‐based adaptive boundary iterative learning control for a rigid‐flexible manipulator with input backlash and endpoint constraint

Nonlinear feedback control of dual-stage actuator system

Robust Synchronization Control by Output Feedback for Dual-cylinder Electro-hydraulic Drive Lift System