Abstract:We experimentally demonstrate the collective emission behavior and suppressed cavity-pulling effect of four-level active optical clock with Cesium atoms. Thermal Cesium atoms in a glass cell velocity selective pumped with a 455.5 nm laser operating at 6S_1/2 to 7P_3/2 transition are used as lasing medium. Population inverted Cesium atoms between 7S_1/2 and 6P_3/2 levels are optical weakly coupled by a pair cavity mirrors working at deep bad-cavity regime with a finesse of 4.3, and the ratio between cavity bandwidth and gain bandwidth is approximately 45. With increased 455.5 nm pumping laser intensity, the output power of cesium active optical clock at 1469.9 nm from 7S_1/2 level to 6P_3/2 level shows a threshold and reach a power of 13 μW. Active optical clock would dramatically improve the optical clock stability since the lasing frequency does not follow the cavity length variation exactly, but in a form of suppressed cavity pulling effect. In this letter the cavity pulling effect is measured using a Fabry-Perot interferometer (FPI) to be reduced by a factor of 38.2 and 41.4 as the detuning between the 1469.9 nm cavity length of the Cs active optical clock and the Cs 1469.9 nm transition is set to be 140.8 MHz and 281.6 MHz respectively. The mechanism demonstrated here is of great significance for new generation optical clocks and can be applied to improve the stability of best optical clocks by at least two orders of magnitude.

Resent Progresses of Dual-Wavelength Good-Bad Cavity Active Optical Clock

Dual-Wavelength Good–Bad-Cavity Laser System for Cavity-Stabilized Active Optical Clock

Dual-wavelength Laser System and Cavity Stabilization Scheme of Dual-Wavelength Active Optical Clock

Dual-wavelength active optical clock

Realization of phase locking in good-bad-cavity active optical clock

The Suppressed Cavity-Pulling Effect in Dual-Wavelength Active Optical Clock Based on Twice Cavty-Locking Technique

Preliminary Results of Active Optical Clock with Cavity-Length Stabilization

Experimental Scheme of 633nm and 1359nm Good-Bad Cavity Dual-Wavelength Active Optical Frequency Standard

Dual-Wavelength Bad Cavity Laser As Potential Active Optical Frequency Standard

Prospects for an Active Optical Clock Based on Cavityless Lasing

A Highly Integrated Single-Mode 1064 Nm Laser with 8.5 Khz Linewidth for Dual-Wavelength Active Optical Clock.

Optical-lattice-based Cs Active Clock with a Continual Superradiant Lasing Signal

Optimization of Pumping Light for Cs Four-level Active Optical Clock

Lasing of Cesium Four-Level Active Optical Clock

Lasing and Suppressed Cavity-Pulling Effect of Cesium Active Optical Clock

External Cavity Diode Laser with Long-Term Frequency Stabilization Based on Mode Boundary Detection

Active Optical Clock

Different Ways to Active Optical Frequency Standards

Measuring the Cavity-Pulling Coefficient of Active Optical Clock Via Pump Laser Modulation

Research on Cs Active Faraday Optical Frequency Standard with 459 Nm Laser Pumping

Active Optical Clock Lasing on the Cs 7S1/2-6P3/2 Transition under a Weak Magnetic Field