Abstract:High-performance flexible strain sensors are urgently needed with the rapid development of wearable intelligent electronics. Here, a bifiller of carbon nanotubes (CNTs) and graphene (GR) for filling flexible porous polydimethylsiloxane (CNT-GR/PDMS) nanocomposites is designed and prepared for strain-sensing applications. The typical microporous structure was successfully constructed using the Soxhlet extraction technique, and the connected CNTs and GR constructed a perfect three-dimensional conductive network in the porous skeleton. As a result, the stretchability and sensitivity of the CNT-GR/PDMS-based strain sensors were well regulated based on the porous structure and the typical synergistic conductive network. Based on the destruction effect of the brittle synergistic conductive network located in the outer and inner layers of the cell skeleton and the contact effect between adjacent cells in different strain ranges, the prepared CNTs-GR/PDMS-based strain sensor exhibited superior gauge factors of 182.5, 45.6, 70.2, and 186.5 in the 0-3, 3-57, 57-90, and 90-120% strain regions, respectively. In addition, this material also exhibited an ultralow detection limit (0.5% strain), a fast response time (60 ms), good stability and durability (10,000 cycles), and frequency-/strain-dependent sensing performances, making it active for the detection of various external environments. Finally, the prepared porous CNTs-GR/PDMS-based strain sensor was attached to the skin to detect various human motions, such as wrist bending, finger bending, elbow bending, and knee bending, thereby demonstrating wide application prospects in smart wearable devices.

Low-cost highly sensitive strain sensors for wearable electronics

Flexible and Highly Sensitive Strain Sensors Fabricated by Pencil Drawn for Wearable Monitor

Highly Stable Kirigami-Structured Stretchable Strain Sensors For Perdurable Wearable Electronics

Stretchable, Sensitive Strain Sensors with a Wide Workable Range and Low Detection Limit for Wearable Electronic Skins

A facile approach to fabricate highly sensitive, flexible strain sensor based on elastomeric/graphene platelet composite film

A Stretchable and Flexible Strain Sensor Based on Graphene Sponge

Wearable Strain Sensors Based on a Porous Polydimethylsiloxane Hybrid with Carbon Nanotubes and Graphene

Graphene Oxide/graphite Nanosheets Composite Thin Films for Wearable Strain Sensors

Wearable and Highly Sensitive Graphene Strain Sensors for Human Motion Monitoring

Highly Linear and Low Hysteresis Porous Strain Sensor for Wearable Electronic Skins

Large‐Area Ultrathin Graphene Films by Single‐Step Marangoni Self‐Assembly for Highly Sensitive Strain Sensing Application

A Single-material-printed, Low-cost design for a Carbon-based fabric strain sensor

A review of wearable carbon-based sensors for strain detection: fabrication methods, properties, and mechanisms

Highly Stretchable and Sensitive Strain Sensor Based on a Simple Friction-Transfer Method

Advances in graphene-based flexible and wearable strain sensors

Highly Stretchable, Ultrasensitive, and Wearable Strain Sensors Based on Facilely Prepared Reduced Graphene Oxide Woven Fabrics in an Ethanol Flame.

Precise Engineering of Conductive Pathway by Frictional Direct-Writing for Ultrasensitive Flexible Strain Sensors.

A graphite nanoplatelet-based highly sensitive flexible strain sensor

Wearable strain sensors for human motion detection and health monitoring based on hybrid graphite-textile flexible electrodes

Highly Sensitive and Stretchable Piezoresistive Strain Sensor Based on Conductive Poly(styrene-Butadiene-styrene)/few Layer Graphene Composite Fiber Part A Applied Science and Manufacturing

Ultrasensitive and Stretchable Resistive Strain Sensors Designed for Wearable Electronics