Abstract:The traditional kinematic calibration method for manipulators requires precise three-dimensional measuring instruments to measure the end pose, which is not only expensive due to the high cost of the measuring instruments but also not applicable to all manipulators. Another calibration method uses a camera, but the system error caused by the camera's parameters affects the calibration accuracy of the kinematics of the robot arm. Therefore, this paper proposes a method for calibrating the geometric parameters of a kinematic model of a manipulator based on monocular vision. Firstly, the classic Denavit-Hartenberg(D-H) modeling method is used to establish the kinematic parameters of the manipulator. Secondly, nonlinear optimization and parameter compensation are performed. The three-dimensional positions of the feature points of the calibration plate under each manipulator attitude corresponding to the actual kinematic model and the classic D-H kinematic model are mapped into the pixel coordinate system, and the sum of Euclidean distance errors of the pixel coordinates of the two is used as the objective function to be optimized. The experimental results show that the pixel deviation of the end pose corresponding to the optimized D-H kinematic model proposed in this paper and the end pose corresponding to the actual kinematic model in the pixel coordinate system is 0.99 pixels. Compared with the 7.9 deviation pixels between the pixel coordinates calculated by the classic D-H kinematic model and the actual pixel coordinates, the deviation is reduced by nearly 7 pixels for an 87% reduction in error. Therefore, the proposed method can effectively avoid system errors caused by camera parameters in visual calibration, can improve the absolute positioning accuracy of the end of the robotic arm, and has good economy and universality.

Vision-Based Method Of Kinematic Calibration And Image Tracking Of Position And Posture For 3-Rps Parallel Robot

An Optimization Based Vision Calibration Method for PTZ Camera's Errors in Model and Execution

Robot Base Frame Calibration with a 2D Vision System for Mobile Robotic Drilling

A Novel Method on Parallel Robot's Pose Measuring and Calibration

A Vision-Based Simultaneous Calibration Method for Dual-Robot Collaborative System

Hand-eye calibration method with a three-dimensional-vision sensor considering the rotation parameters of the robot pose

A Vision-Based Fully-Automatic Calibration Method for Hand-Eye Serial Robot

A Calibration Method for Overconstrained Spatial Translational Parallel Manipulators

Calibration Methods of Planar Parallel Robot

A vision-based self-calibration method for robotic visual inspection systems

Kinematic Calibration Of Parallel Robots Using Pose Measurement Obtained With Coordinate Measuring Machine

Online robot calibration based on vision measurement

An Online Intelligent Kinematic Calibration Method for Quadruped Robots Based on Machine Vision and Deep Learning

Robot calibration using a 3D vision-based measurement system with a single camera

A Visual Kinematics Calibration Method for Manipulator Based on Nonlinear Optimization

Automatic Robot Hand-Eye Calibration Enabled by Learning-Based 3D Vision

Error modeling and kinematic calibration of parallel robots

UNCALIBRATED 3D ROBOTIC VISUAL TRACKING BASED ON STEREO VISION

Measurement Configuration Optimization and Kinematic Calibration of a Parallel Robot

An Automatic High-Precision Calibration Method of Legs and Feet for Quadruped Robots Using Machine Vision and Artificial Neural Networks

Kinematic calibration of parallel robots using orientation constraint