Co-production of hydrogen-rich gas and porous carbon by partial gasification of coal char

Jianbo Zhang,Guorong Zhang,Meng Qi,Haoquan Hu,Xiaoxun Ma
DOI: https://doi.org/10.1007/s11696-017-0278-5
IF: 2.146
2017-01-01
Chemical Papers
Abstract:An industrial coal char from coal pyrolysis was used for simultaneous preparation of hydrogen-rich gas and porous carbon by catalytic steam gasification. The effects of K 2 CO 3 as a catalyst under varying steam flow rates, reaction temperatures, mass ratios of CC:K 2 CO 3 and reaction times were investigated on hydrogen output and textural properties of the produced porous carbons. The suitability of CaO and the packing pattern were also examined for CO 2 capture, thereby promoting hydrogen content in the outlet gas. The results show that in a single operating system and process, stable and consistent hydrogen-rich gas and porous carbon can be simultaneously produced by partial or incomplete gasification. At the optimized gasification conditions, hydrogen output can be up to 3.2–3.5 mmol/(min•g CC ). H 2 and CO 2 were the dominant species sharing around 65% and 30% of the produced gas (dry basis), respectively, while only small CO and CH 4 fractions were observed. The surface area and total pore volume of the produced porous carbon can reach up to 812 m 2 /g and 0.473 cm 3 /g, respectively. The maximum hydrogen content of 95 vol.% (dry basis) can be achieved at the initial stage with some additional CaO by using either homogeneous or heterogeneous configuration. Graphical Abstract
What problem does this paper attempt to address?