Abstract:Polymer electrolyte fuel cells (PEFCs) are expected as one of the clean, highly effective energy conversion systems, and have been actively studied. Pt nanoparticles on carbon supports (Pt/C) are commonly used as a cathode catalyst for PEFCs, because of the high activity on oxygen reduction reaction (ORR). However, its durability in long term driving and high mass activity for ORR have not sufficiently fulfilled at the present. More improvements of Pt/C catalyst for ORR activity and the durability are required for the spread of PEFCs To improve the activity and durability of Pt/C, ionic liquids (ILs) modified catalysts, called Pt/C-Solid catalysis with an IL layer (SCILL) catalysts, have recently attracted much attention [1]. ILs are liquid salts around room temperature, which have high ionic conductivity and electrochemical stability. We focused on hydrophobic ionic liquids with quaternary phosphonium cations [2]. Quaternary phosphonium cations ionic liquids have higher ionic conductivity and hydrophobicity than quaternary ammonium ionic liquids with the same structure and the same counter ions. Because of interference in the oxygen reduction reaction on platinum by water, increasing the hydrophobicity of the surface is expected to improve the activity on Pt/C catalysis. Hence, by using the quaternary phosphonium cations ILs for Pt/C-SCILL catalysts, it promises to improve the ORR activities for the catalyst. On the other hand, proton conduction and oxygen permeation rate are also important factors for ORR activity enhancement. In this study, we report the ORR activity for Pt/C-SCILL catalysts with ILs composed of highly hydrophobic cations and hydrophobic anions. Quaternary phosphonium based ILs (PXXXY+TFSA-[alkyl chain X= 4 Y= 1, 12, 16]) were used for Pt/C-SCILL modified electrodes. Commercially available 20 wt% or 30 wt% Pt/C (Cabot, Vulcan XC-72RR) catalyst was used for bare Pt/C modified electrodes. The ultrasonicated Pt/C catalyst suspension was dropped on the mirror polished glassy carbon disk electrodes. Pt/C-SCILL modified electrodes were prepared by recasting the ILs-2-propanol solution on the bare Pt/C modified electrodes or adding ILs to the catalyst suspension. Moreover, the mixture of the ILs and bis(trifluoromethanesulfonyl)imide (HTFSA) were also examined. The thickness of the ILs layer was calculated relative to the BET surface area of the carbon support. A platinum wire and a reversible hydrogen electrode (RHE) were used as the counter and reference electrodes, respectively. CV and LSV were carried out in 0.1 M HClO4 solution under Ar (CV) or O 2 (LSV) atmosphere, respectively. The Pt/C-SCILL catalyst was prepared by recasting (thin layers, ~0.4 nm) or mixing (thick layers, 1nm~) methods. In the case of the thin layer (~0.4 nm) of ILs, the ORR activity increased as the size of the cations increased. However, for the thicker (1 nm ~) ILs layers, the ORR activity was lower than for the bare Pt/C catalysts. It seems that the aprotic ILs interfered with the proton supply, making the four-electron reduction reaction of oxygen less likely to occur. Therefore, we attempted to supply protons to the thick ILs layer by mixing an ionic liquid with a proton source. HTFSA was dissolved in P444(12)TFSA, which showed relatively good ORR activity in thin film studies. The Pt/C-SCILL catalyst was prepared by adding the mixture with a catalyst dispersion. This proton mixing Pt/C-SCILL catalyst showed a significant improvement in ORR activity compared to bare Pt/C catalyst. References [1] S. Silvia et al., Adv. Energy Sustainability Res., 2, 2000062 (2021). [2] K. Tsunashima and M. Sugiya, Electrochem. Commun., 9, 2353 (2007).

Oxygenophilic ionic liquids promote the oxygen reduction reaction in Pt-free carbon electrocatalysts

The Activity Enhancement Effect of Ionic Liquids on Oxygen Reduction Reaction Catalysts: From Rotating Disk Electrode to Membrane Electrode Assembly

Revealing the role of ionic liquids in promoting fuel cell catalysts reactivity and durability

Modifying the Cathode Catalyst Layer in PEM Fuel Cells with Ionic Liquids for Improved Oxygen Reduction Reaction

Ionic Liquid Modification of High-Pt-Loading Pt/C Electrocatalysts for Proton Exchange Membrane Fuel Cell Application

Enhancing the Oxygen Reduction Reaction by Anchoring Proton Close to the Electrode Surface

(Digital Presentation) Rotating Ring-Disk Electrodes Studies on Oxygen Reduction Reaction at Hydrophobic Ionic Liquids Layer Modified Pt/C Catalyst

Increasing Accessible Active Site Density of Non-Precious Metal Oxygen Reduction Reaction Catalysts through Ionic Liquid Modification

Enhancing oxygen reduction electrocatalysis by tuning interfacial hydrogen bonds

Interfacial Water Manipulation with Ionic Liquids for the Oxygen Reduction Reaction

Engineering both intrinsic characteristic and local microenvironment of platinum sites toward highly efficient oxygen reduction reaction

Ionic Liquid Additives for the Mitigation of Nafion Specific Adsorption on Platinum

Optimizing the Electronic Structure of Ordered Pt–Co–Ti Ternary Intermetallic Catalyst to Boost Acidic Oxygen Reduction

Impact of a protic dimeric ionic liquid on PEM fuel cell performance and durability

Ionic Liquids Combined with Pt-modified Ordered Mesoporous Carbons As Electrolytes for the Oxygen Sensing

(Invited) Oxygen Reduction at Low-Pt-Content-Catalysts in Acid Media: Development of Systems and Electroanalytical Diagnostic Methodology

An Efficient and Green Approach to Prepare Hydrophilic Imidazolium Ionic Liquids Free of Halide and Its Effect on Oxygen Reduction Reaction of Pt/C Catalyst

Introduction of Surface Modifiers on the Pt-Based Electrocatalysts to Promote the Oxygen Reduction Reaction Process

An Efficient Electrocatalyst (PtCo/C) for the Oxygen Reduction Reaction

(Invited) Enhancement of Activity of Low-Pt-Content-Catalysts Toward Oxygen Reduction through Admixing with Metal Oxide Cocatalysts

Fe azaphthalocyanine unimolecular layers (Fe AzULs) on carbon nanotubes for realizing highly active oxygen reduction reaction (ORR) catalytic electrodes