Abstract:Journal of Composite Materials, Ahead of Print. The multi-directional laminate CCF800H/AC631 bismaleimide composite material was exposed for a long time under the thermal-cycling environment (−60°C ∼+180°C), and the mass loss rate, FTIR spectra, DMA, tensile strength were tested. The fatigue stress level was determined according to the tensile strength and the fatigue performance of the before and after the thermal-cycling environment was tested. Macroscopic visual inspection and ultrasonic C-scan were used to characterize and analyze the fatigue damage of composite materials. The results show that with the increase in the number of thermal cycles, the mass loss of the composite material started with increased rapidly and then basically flat. The C/BMI composites underwent obvious thermal oxygen aging. After thermal-cycling, it would lead to changes in dynamic mechanical properties by a certain degree of post-curing, physical aging, and local interface debonding in composite materials. With the thermal cycles increased the composite material tensile strength first increased slightly and then decreased rapidly. After 300 thermal cycles, the composite materials occurred slightly damaged, and the fatigue life was apparently reduced compared with the original state. The fatigue failure modes of composite materials are mainly fiber fracture and multi-directional laminate delamination. At high stress levels, the stiffness of the specimen after thermal-cycling are lower decrease compared with original specimens, more stress levels would lead to more II stage rate of stiffness decline, and stiffness degradation curve and hysteretic energy recovery curve had enough effect to characterize damage effect of material environment induced by thermal-cycling environment factors.

Analyzing Hysteresis and Thermal Expansion Coefficient of M40/AZ91D During Thermal Cycling

Thermal expansion and dimensional stability of unidirectional and orthogonal fabric M40/AZ91D composites

Effect of Vacuum Thermo-Cycling on Physical Properties of Unidirectional M40J/AG-80 Composites

Thermal cycles behavior and microstructure of AZ31/SiC composite prepared by stir casting

Effect of Applied Stress Combined with Thermal Cycling on Plasticity of Mg_2B_2O_(5w)/AZ31B Composites

Microstructure and Mechanical Properties of M40/AZ91 Composites Fabricated by Pressure Infiltration Method

Interface and Thermal Expansion of Carbon Fiber Reinforced Aluminum Matrix Composites

Nonlinear temperature characteristic of thermal expansion of Grf/Mg composites

Thermal Shock Behavior of Twill Woven Carbon Fiber Reinforced Polymer Composites

Effect of thermal cycling on the mechanical properties of Cf/Al composites

Tensile Deformation and Fracture of Unreinforced AZ91 and Reinforced AZ91-C at Temperatures up to 300 °C

Compressive Deformation Behavior of the SiCw/AZ91 Composite at Elevated Temperatures

The Effect of Phase Transformation on the Thermal Expansion Property in Al/ZrW 2 O 8 Composites

Thermal cycling of silicon carbide whisker reinforced ZL101A composite

Coefficient of thermal expansion and compute of carbon fibre reinforced magnesium composites

Variation of the Thermal Stress in the Al18b4o33w/Al Composite During Low Temperature Cycling

High Temperature Damping Behavior of As-Deformed Mg Matrix Influenced by Micron and Submicron SiCp

Characterization on fatigue behavior and damage mechanism of C/BMI composites experienced thermal cycling

Thermal expansion properties of TiC particle reinforced ZA43 matrix composite

Microstructure of C fibre reinforced AZ91D composites

HOT DEFORMATION BEHAVIOR OF SiCw/AZ91 MAGNESIUM MATRIX COMPOSITE AND AZ91 ALLOY