Abstract:Many components in secondary side of pressurized water reactors (PWRs) are made of carbon steels and low alloy steels. The corrosion products produced by the flow accelerated corrosion (FAC) of these components can deposite on the surface of steam generator (SG) tubes and decrease the heat transfer efficiency of SG tubes. Moreover, the enrichment of foreign ions (e.g. Cl- and Pb2+) occurs with the sedimentation of corrosion products and causes the local environment degradation, and thus accelerates the failure of SG tubes. In order to decrease the FAC of carbon steels and low alloy steels, pH controllers are often added to adjust the pH value of secondary water. The water chemistry environment of secondary side in PWRs has experienced various treatment techniques, such as phosphate treatment, all volatile treatment (AVT), morpholine (MPH) treatment, ethanolamine (ETA) treatment, and boric acid treatment. In comparision with AVT, ETA can significantly reduce the concentration of Fe in the steam-water phase region and water supply system because of its higher alkalinity and lower molar concentration in feedwater. Due to the high resistance to corrosion and stress corrosion cracking in high temperature and high pressure water, alloy 800 is often used as steam generator tubes in nuclear power plants and thus becomes increasingly attractive among researchers. However, few studies focus on the effect of ETA on the corrosion behavior of alloy 800 in high temperature and high pressure water. This work mainly aims to investigate the corrosion behavior of alloy 800 in NaOH and ETA solutions at 300 degrees C by potentiodynamic polarization curve, electro-chemical impedance spectra (EIS), SEM and XPS. The electrochemical results demonstrate that the addition of ETA decreases the current density of anodic and cathodic reactions, and increases the corrosion potential of alloy 800. Besides, ETA addition significantly increases the resistance of inner oxide layer and makes the oxide film more compact, which increases the film resistance of alloy 800 in high temperature water. Through the morphology observation and composition analysis, it is found that ETA addition can promote the formation of Cr-rich layer and increase the ratio of chromium in the oxide films although the deposition of magnetite is enhanced on the surface of alloy 800. For stainless steels and nickel-based alloys in high temperature water, the Cr-rich oxide layer can inhibit the diffusion process of 0 and metal ions, and reduces the corrosion rates of alloys. Therefore, the corrosion resistance of alloy 800 is enhanced after ETA is added in high temperature water.

Electrochemical Corrosion Behavior of TC11 Alloy in Sulfate Solution at High Temperature and High Pressure

Corrosion behavior for Alloy 690 and Alloy 800 tubes in simulated primary water

Effect of the ultrasonic surface rolling process and plasma electrolytic oxidation on the hot salt corrosion fatigue behavior of TC11 alloy

Corrosion Behavior of Alloy 800 in Naoh and Eta Solutions at 300 Degrees C

Corrosion behavior of nickel base alloys, stainless steel and titanium alloy in supercritical water containing chloride, phosphate and oxygen

Corrosion behaviour of a wrought Ti-6Al-3Nb-2Zr-1Mo alloy in artificial seawater with various fluoride concentrations and pH values

Corrosion Behavior Ofin-Situtib2/7050al Composite in NaCl Solution at Different Ph Values

Corrosion behavior and electrochemical properties of carbon steel, commercial pure titanium, copper and copper–aluminum–nickel alloy in 3.5% sodium chloride containing sulfide ions

Corrosion Behavior of the AlCoCrFeNi2.1 Eutectic High-Entropy Alloy in Chloride-Containing Sulfuric Acid Solutions at Different Temperatures

Electrochemical Corrosion Behavior of Biomedical Ti–22Nb and Ti–22Nb–6Zr Alloys in Saline Medium

Electrochemical Polarization and Corrosion Behavior of Al–Zn–In Based Alloy in Acidity and Alkalinity Solutions

CORROSION BEHAVIOR OF NUCLEAR GRADE ALLOYS 690 AND 800 IN SIMULATED HIGH TEMPERATURE AND HIGH PRESSURE PRIMARY WATER OF PRESSURIZED WATER REACTOR

The Corrosion Behavior of Ti-6Al-3Nb-2Zr-1Mo Alloy: Effects of HCl Concentration and Temperature

Electrochemical Study on Corrosion Process Characteristics of the High-Strength Low-Alloy Steels in NaHSO 3 Solution

Effects of alternating dissolved oxygen and dissolved hydrogen on the corrosion behavior of alloy 52 in high temperature high pressure water

The electrochemical behavior of a Ti50Ni47Fe3 shape memory alloy

Corrosion behavior of AA5052 aluminum alloy in the presence of heavy metal ions in 3.5 % NaCl solution under negative pressure

Annealed microstructure dependent corrosion behavior of Ti-6Al-3Nb-2Zr-1Mo alloy

Study on the Corrosion Behavior and Numerical Simulation of TC18 Titanium Alloy under Tensile Stress

Corrosion Behaviour of Ti–Nb–Sn Shape Memory Alloys in Different Simulated Body Solutions

Electrochemical Hydrogen Charging on Corrosion Behavior of Ti-6Al-4V Alloy in Artificial Seawater