Abstract:In this article, a direct and inverse iteration design method for mixed-flow pumps was introduced, and a three-dimensional design platform for mixed-flow pumps was established. Through iteration calculation of two kinds of stream surfaces to solve both the continuity equation and motion equation of the fluid at the same time, and therefore obtaining the quasi-three-dimensional flow field inside the mixed-flow pump, the accuracy of the flow field calculation was improved. By repeating iteration of the direct calculation and inverse design, influence of blade shape on flow field calculation was fully considered, thus assuring that the final design of blade camber line complies with actual flow pattern. After comparing and analyzing the meridional velocity distribution, as well as the relative circulation distribution and expelling coefficient in the blade zone, it was proved that compared with others designed by conventional methods, the impeller designed with three-dimensional design platform has a better hydraulic performance, especially the blade energy conversion capacity that witnessed a significant improvement. With this three-dimensional design platform, a parametrization was applied to velocity moment distribution and blade leading and trailing edges positions. The influence of velocity moment distribution parameters P and a0, and the blade leading and trailing edges positions parameters θh and θt on blade wrap angle and the internal flow of the impeller were analyzed. By curve fitting, the functional relationship between blade wrap angle ϕ and parameters θt, P and a0 was obtained. The blade wrap angle control strategy during the process of mixed-flow pump impeller design was then put forward, thus realizing three-dimensional design of mixed-flow pump blades with controllable blade wrap angle. The performance test for the mixed-flow pump model suggested that the three-dimensional design method with controllable blade wrap angle, by controlling blade wrap angle size and adopting direct and inverse iteration design method, ensures a better hydraulic and cavitation performance for the mixed-flow pump impeller designed with three-dimensional design platform.

Inverse Method of Centrifugal Pump Impeller Based on Proper Orthogonal Decomposition (POD) Method

Knowledge Mining of Low Specific Speed Centrifugal Pump Impeller Based on Proper Orthogonal Decomposition Method

An Iterative Inverse Design Method of Turbomachinery Blades by Using Proper Orthogonal Decomposition

Optimization method investigation for centrifugal pump performance based on 3D inviscid inverse design

Inverse Design of Two-Dimensional Turbine Blades by Using Gappy POD

Flow Reconstructions and Aerodynamic Shape Optimization of Turbomachinery Blades by POD-based Hybrid Models

Inverse Method of Centrifugal Pump Blade Based on Gaussian Process Regression

Direct and Inverse Iterative Design Method for Centrifugal Pump Impellers

Optimization of a Centrifugal Impeller on Blade Thickness Distribution to Reduce Hydro-Induced Vibration

Inverse Design Of Impeller Blade Of Centrifugal Pump With A Singularity Method

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

AN EFFICIENT METHOD FOR FLOW FIELD INVERSE DESIGN

Design Optimization of the Last Stage of a 4.5-Stage Compressor Using a POD-based Hybrid Model

Iteration method of direct inverse problem of mixed-flow pump impeller design

Optimal Design of Mixed-Flow Pump Impeller Based on Direct Inverse Problem Iteration and Genetic Algorithm

Effect of the Blade Loading Distribution on Hydrodynamic Performance of a Centrifugal Pump with Cylindrical Blades

Optimization of the hydraulic pre formance of a centrifugal pump impeller based on the blade load distribution

Three-dimensional Design Method for Mixed-Flow Pump Blades with Controllable Blade Wrap Angle

A Novel Design of Centrifugal Pump Impeller for Hydropower Station Management Based on Multi-Objective Inverse Optimization

Airfoil Inverse Design Method Based on Two-layer POD and BPNN

An adjoint-based optimization method for reducing the axial force of a reactor coolant pump