Abstract:For advanced performance lithium-ion batteries (LIBs) various novel electrode materials with high energy density have been extensively investigated. Cobaltosic oxide (Co3O4), commonly used as an anode in LIBs, has attracted much interest because of its high theoretical specific capacity (890 mAh center dot g(-1)), high tap density, and stable chemical properties. However, its practical use has been hindered because of its low electronic conductivity and poor rate capability. To address these problems, we investigated a liquid phase precipitation method followed by thermal treatment and obtained a unique lamellar Co3O4 powder. Its X-ray diffraction (XRD) diffraction peaks match the standard pattern for cubic phaseCo(3)O(4) with good crystallinity. We found that the Co3O4 powder consists of many irregular sheets (1.5-3.0 mu m in diameter, 100-300 nm in thickness) with numerous poles by scanning electronmicroscopy (SEM). Additionally, the surface area was about 30.5m(2) center dot g-1, and this was calculated from BET nitrogen adsorption isotherm measurement data. Remarkably, perfect performance was obtained as evaluated by electrochemical measurements, including a high initial discharge capacity (1444.5 mAh center dot g(-1) at 0.1C) and excellent capacity retention (charge capacity after 50 cycles was still greater than 1100.0 mAh center dot g(-1) at 0.1C). However, its rate capability was still not adequate (75.3% of the first charge capacity after 50 cycles at 1C). To improve the rate capability, commercial carbon nanotubes (CNTs) mixed with the Co3O4 powder was used to enhance the electronic conductivity. The charge capacity retention ratios were 96.3% after 70 cycles at 1C and 97.0% after 50 cycles at 2C. Therefore, enhanced electrochemical performance with impressive rate capability was obtained, as expected.

Co3O4 Microtubules Derived from a Biotemplated Method for Improved Lithium Storage Performance

Mesoporous Co3O4 and CoO@C Topotactically Transformed from Chrysanthemum-like Co(CO3)0.5(OH)center dot 0.11H2O and Their Lithium-Storage Properties

Micro-/Nanostructured Co3O4 Anode with Enhanced Rate Capability for Lithium-Ion Batteries

Cobalt oxide hollow microspheres with micro- and nano-scale composite structure: Fabrication and electrochemical performance

A Co3O4/C Composite for Use As a High-Performance Lithium-Ion Battery Anode

Morphology-controlled synthesis of Co3O4 porous nanostructures for the application as lithium-ion battery electrode

Co3O4 nanosheets anchored on C/Cu porous microspheres as high-performance anode materials for lithium-ion battery

High-performance Lithium Storage of Co3O4 Achieved by Constructing Porous Nanotube Structure

Oxidizing Solid Co into Hollow Co3O4 within Electrospun (Carbon) Nanofibers towards Enhanced Lithium Storage Performance

Simple pyrolysis of cobalt alginate fibres into Co3O4/C nano/microstructures for a high-performance lithium ion battery anode

Synthesis of cobalt ion-based coordination polymer nanowires and their conversion into porous Co3O4 nanowires with good lithium storage properties

Micro/nano-structure Co3O4 as high capacity anode materials for lithium-ion batteries and the effect of the void volume on electrochemical performance

Facile Synthesis of Porous Co3O4 Nanosheets Containing Abundant Oxygen Vacancies for Boosted Lithium-Ion Storage

Preparation and Electrochemical Performance of Various Morphologies Cobalt Oxide as Anode Materials for Lithium-ion Batteries

Manganous Oxide-Cobalt@carbon Microcubes with a Hierarchical Mesoporous Structure for High Performance Lithium Storage

A Facile Strategy for Co3O4/Co Nanoparticles Encapsulated in Porous N-doped Carbon Nanofibers Towards Enhanced Lithium Storage Performance

Controlling Morphologies and Tuning the Properties of Co3O4 with Enhanced Lithium Storage Properties

MnCo2O4 Nanospheres for Improved Lithium Storage Performance

Mesoporous Tubes Composed of Graphitic Carbon-Doped Co 3 O 4 Nanoparticles for Lithium Storage

Preparation and Electrochemical Performance of Nanosized Co3O4 Via Hydrothermal Method

Synthesis and Modification of a Lamellar Co3O4 Anode for Lithium-Ion Batteries