Application of Three-Dimensional Printing Technology in Oral and Maxillofacial Reconstruction

L. Zhang,X.F. Shan,J. Liang,Y. He,Y. Zhang,Z.G. Cai

DOI: https://doi.org/10.1016/j.ijom.2017.02.671

IF: 2.986

2017-01-01

International Journal of Oral and Maxillofacial Surgery

Abstract:Objective: To explore the clinical application of three-dimensional (3D) printing technique in oral and maxillofacial reconstruction. Methods: From January 2010 to December 2015, all of the clinical cases, which were reconstructed by microvascular free flap due to oral and maxillofacial defects in our department were followed up. Suitable cases were selected to using 3D printing technology for preoperative preparation, surgical implement and postoperative evaluation. All the clinical data were collected. Results: In the past five years, 3D printing technique was used in 27 clinical cases which microvascular free flap was used to reconstruct oral and maxillofacial defect. In our study, rapid prototyping 3D printing models were used to simulate the tumour ablation and evaluate the defect extension in 14 cases. In another 10 cases, 3D printed surgical templates were printed according to the preoperative digital design. For the third part, patient-specific maxillofacial implant were printed using 3D printing technique in three cases. All of the free flaps were survived and the final reconstructed results were satisfied in all patients. Conclusion: 3D printing technique had promising implication in oral and maxillofacial reconstruction. Preoperative rapid prototyping 3D printing model could be used to predict the extension of defects, simulate the reconstruction operation and prefabricated titanium mesh or plate. 3D printed surgical template was helpful for the accurate implementation of surgical plan.3D printing patient-specific implants were very useful to reconstruct complex 3 dimensional defects and obtain the best reconstructive result.