Abstract:Purpose: The appearance of x-ray luminescence computed tomography (XLCT) opens new possibilities to perform molecular imaging by x ray. In the previous XLCT system, the sample was irradiated by a sequence of narrow x-ray beams and the x-ray luminescence was measured by a highly sensitive charge coupled device (CCD) camera. This resulted in a relatively long sampling time and relatively low utilization of the x-ray beam. In this paper, a novel cone beam x-ray luminescence computed tomography strategy is proposed, which can fully utilize the x-ray dose and shorten the scanning time. The imaging model and reconstruction method are described. The validity of the imaging strategy has been studied in this paper.Methods: In the cone beam XLCT system, the cone beam x ray was adopted to illuminate the sample and a highly sensitive CCD camera was utilized to acquire luminescent photons emitted from the sample. Photons scattering in biological tissues makes it an ill-posed problem to reconstruct the 3D distribution of the x-ray luminescent sample in the cone beam XLCT. In order to overcome this issue, the authors used the diffusion approximation model to describe the photon propagation in tissues, and employed the sparse regularization method for reconstruction. An incomplete variables truncated conjugate gradient method and permissible region strategy were used for reconstruction. Meanwhile, traditional x-ray CT imaging could also be performed in this system. The x-ray attenuation effect has been considered in their imaging model, which is helpful in improving the reconstruction accuracy.Results: First, simulation experiments with cylinder phantoms were carried out to illustrate the validity of the proposed compensated method. The experimental results showed that the location error of the compensated algorithm was smaller than that of the uncompensated method. The permissible region strategy was applied and reduced the reconstruction error to less than 2 mm. The robustness and stability were then evaluated from different view numbers, different regularization parameters, different measurement noise levels, and optical parameters mismatch. The reconstruction results showed that the settings had a small effect on the reconstruction. The nonhomogeneous phantom simulation was also carried out to simulate a more complex experimental situation and evaluated their proposed method. Second, the physical cylinder phantom experiments further showed similar results in their prototype XLCT system. With the discussion of the above experiments, it was shown that the proposed method is feasible to the general case and actual experiments.Conclusions: Utilizing numerical simulation and physical experiments, the authors demonstrated the validity of the new cone beam XLCT method. Furthermore, compared with the previous narrow beam XLCT, the cone beam XLCT could more fully utilize the x-ray dose and the scanning time would be shortened greatly. The study of both simulation experiments and physical phantom experiments indicated that the proposed method was feasible to the general case and actual experiments. (C) 2013 American Association of Physicists in Medicine.

Image Deblurring Using a Joint Entropy Prior in X-Ray Luminescence Computed Tomography

A Wavelet-Based Single-View Reconstruction Approach for Cone Beam X-Ray Luminescence Tomography Imaging.

Direct Prior Regularization from Anatomical Images for Cone Beam X-Ray Luminescence Computed Tomography Reconstruction.

Regularized Reconstruction Based on Joint L1 and Total Variation for Sparse-View Cone-Beam X-ray Luminescence Computed Tomography.

OPK_SNCA: Optimized Prior Knowledge Via Sparse Non-Convex Approach for Cone-Beam X-ray Luminescence Computed Tomography Imaging

X-Ray Luminescence Computed Tomography Imaging Based on X-Ray Distribution Model and Adaptively Split Bregman Method

TU‐G‐110‐09: Spectral CT (SCT) Reconstruction Using Tight Wavelet Frames

X‐ray Luminescence Computed Tomography Using a Hybrid Proton Propagation Model and Lasso‐LSQR Algorithm

Cone Beam X-Ray Luminescence Computed Tomography Based on Bayesian Method

Cone Beam X-Ray Luminescence Computed Tomography: a Feasibility Study.

Cone-beam X-Ray Luminescence Computed Tomography Reconstruction from Single-View Based on Total Variance

Hybrid Simplified Spherical Harmonics With Diffusion Equation For X-Ray Luminescence Computed Tomography

Cone-beam X-Ray Luminescence Computed Tomography Based on X-Ray Absorption Dosage

Task-based image quality evaluation of iterative reconstruction methods for low dose CT using computer simulations

Cone-beam X-ray Luminescence Computed Tomography Based on MLEM with Adaptive FISTA Initial Image

Generalized Adaptive Gaussian Markov Random Field for X-Ray Luminescence Computed Tomography

Hybrid plug-and-play CT image restoration using nonconvex low-rank group sparsity and deep denoiser priors

Dual and Multi-Target Cone-Beam X-ray Luminescence Computed Tomography Based on the DeepCB-XLCT Network

A Method of Extracting Structural Priors from Images of Micro-Ct for Fluorescence Molecular Tomography Reconstruction

Scattering-compensated Cone Beam X-Ray Luminescence Computed Tomography

Enhanced Spatial Resolution in Cone Beam X-ray Luminescence Computed Tomography Using Primal-Dual Newton Conjugate Gradient Method