Abstract:This work investigates the effects of gas preheating and N2 dilution on soot formation in a series of laminar methane (CH4), ethane (C2H6), and propane (C3H8) co-flow diffusion flames. A modified Santoro-type burner was used to produce the flames with a series of preheat temperatures of both co-flow air and inlet fuels between 293 and 723 K. Planar laser-induced incandescence and line-of-sight beam extinction were employed to quantitatively measure the planar distributions of soot volume fractions, and two-color pyrometry was used to measure the soot temperature. The results show that the soot volume fraction significantly increases with the gas preheat temperature for all flames. A rise in the preheat temperature accelerates soot evolution and leads to the higher percentage of carbon conversion to soot in the flames. This enhancement is more remarkable in the flames of fuel with a lower sooting propensity than those with a high sooting propensity. Both axial and radial soot temperatures in the CH4 and C2H6 flames increase with the gas preheat temperature significantly. However, a reverse changing trend is observed in the central region of C3H8 flames, owing to the greater heat losses resulting from the incomplete combustion and strong soot radiation. Adding N2 to the fuel flow suppresses soot formation via the direct dilution effect on the fuel concentration and the indirect effect of changing the flame temperature. As the gas preheat temperature increases, an increasing proportion of the contribution of the direct dilution effect is observed in the N2-diluted C2H6 flames. In addition, the global activation energy of soot formation for the three fuels is estimated on the basis of the measured soot temperature and soot formation rate in the present work.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03426?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03426</a>.Calculated pyrolysis products for (a) CH4, (b) C2H6, (c) N2-diluted (50%) C2H6, (d) C3H8, and (e) N2-diluted (66.7%) C3H8 under different temperatures (Figure S1), relationship between laser fluence and normalized LII signal intensity (Figure S2), vertical laser fluence profile of the laser sheet where the laser fluence was set as approximately 0.3 J/cm2 (Figure S3), and calibrated relationship between soot volume fraction (fv) and LII signal intensity at the height from 15 to 40 mm in the propane flame IV-0, with the solid line representing the fitting curve to the experimental data and the two short dashed lines representing the boundaries of ±15% uncertainty in the fitting correction factor (Figure S4) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03426/suppl_file/ef0c03426_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Empirical Method for Carbonaceous Substances Production Estimation and Effect of N2 During Trifluoromethane Pyrolysis

Effect of Nitrogen/Oxygen Substances on the Pyrolysis of Alkane-Rich Gases to Acetylene by Thermal Plasma

The Effects of CO2/CH4 Ratio on Soot Formation for Autothermal Reforming of Methane at Elevated Pressure

Characterization of CH4-CO2-O2 Diffusion Flames Near Autothermal Reforming Condition

Effect of Pressure and CO2 Dilution on Soot Formation in Laminar Inverse Coflow Flame at Conditions Close to Autothermal Reforming

Quantitative Analysis of Main Components of Natural Gas Based on Raman Spectroscopy

Measurements of position-specific carbon isotopic compositions in propane by on-line Gas Chromatography-Pyrolysis-Gas Chromatography-Isotope Ratio Mass Spectrometer (GC-Py-GC-IRMS) and its preliminary application

Studies on Oligomerization and Kinetic of Pyrolyzing Trifluoromethane to Tetrafluoroethylene and Hexafluoropropylene

Fast Pyrolysis of Methyl Ricinoleate in an Inductively Heated Reactor Coupled with Atomization Feeding

Effects of the Gas Preheat Temperature and Nitrogen Dilution on Soot Formation in Co-flow Methane, Ethane, and Propane Diffusion Flames

Experimental and modeling study of the N, N-dimethylformamide pyrolysis at atmospheric pressure

Experimental and Modelling Studies on Pyrolysis and Its Main Light Gas Products for Typical C8 Hydrocarbons

CH4/N2 Ratio as a Potential Alternative Geochemical Tool for Prediction of Thermal Maturity of Natural Gas in Tarim Basin

A study on the pyrolysis of n-hexane initiated by 1-nitropropane: Molecular dynamics simulations and SVUV-PIMS experiments

Probing the Synergistic Effect of NH3 and N2O Oxidation Using an RCM Coupled with Time-Resolved Molecular Beam Mass Spectrometry

Effect of Ethane and Propane Addition on Acetylene Production in the Partial Oxidation Process of Methane

Simultaneous Measurements of Temperature, CO, and CO2 Time-History in Reacting N-Heptane/o2/argon Mixtures Blended with Diethyl Ether B Ehind Reflecte D Shock Waves

Experimental and Modeling Investigation on the Pyrolysis of n-Decane Initiated by Nitropropane. Part I: 1-Nitropropane

Study on the characteristics of fir pyrolysis and combustion in thermal balance for simulating typical fire condition

Pyrolysis temperature effect on compositions of basic nitrogen species in Huadian shale oil using positive-ion ESI FT-ICR MS and GC-NCD

Numerical Analysis of Methane Pyrolysis in Thermal Plasma for Selective Synthesis of Acetylene