Identification of Al13 on the Colloid Surface Using Surface-Enhanced Raman Spectroscopy

Ning Li,Chengzhi Hu,Xiaoning Fu,Xiufang Xu,Rui Liu,Huijuan Liu,Jiuhui Qu
DOI: https://doi.org/10.1021/acs.est.6b05721
IF: 11.4
2017-01-01
Environmental Science & Technology
Abstract:Al-13 is the most active polymeric Al species responsible for coagulation at the solid-liquid interface, whereas the detection techniques for Al-13 at the interface are currently limited. In this study, for the first time, the identification of Al-13 on the silicon dioxide-based colloid surface was realized by using surface-enhanced Raman scattering (SERS), which is an ideal surface method sensitive for single-molecule detection. The high purity Al-13 salts were prepared by an electrolysis procedure followed by precipitation or metathesis. Al-13-Cl-n was determined to be feasible for the Raman detection as it exhibited more noticeable signals in comparison to Al-13-(SO4)(p) and Al-13-(NO3)(m). The peak of Al-13-Cl-n at 635 cm(-1) could be the major characteristic peak of Al-13, and the other two peaks at 300 and 987 cm(-1) could be accessorial evidence for the identification. Further, the identification of Al-13 adsorbed on the surface of Ag and gold-core/silica-shell colloids was confirmed by the SERS response at the above three wavenumbers with a higher signal-to-noise ratio than the normal Raman scattering. According to the least-squares fitting computed Raman spectra, each of the characteristic peaks was associated with specific vibrational modes.
What problem does this paper attempt to address?