Abstract:A fully superconducting wind generator employs superconductors in stator and rotor to enable high torque density and low weight, that is, enable an ultra-light electric machine for wind application. However, the level of the AC loss of the stator armature coils is a critical issue, which lacks investigations in the design of the fully superconducting generators. In this paper, an in-house model was developed to analyze the potential of a fully superconducting generator by integrating the electromagnetic design with the AC loss estimation. The electromagnetic model was made through analytical equations, which take into consideration the geometry, the magnetic properties of iron, and the nonlinear E–J constitutive law of superconductors. Since the permeability of iron materials and the critical current of the superconductors depend on the magnetic field, an iteration process was proposed to find their operating points for every electromagnetic design. The AC loss estimation was carried out through finite element software based on the T–A formulation of Maxwell’s equations instead of analytical equations, due to the complexity of magnetic fields, currents and rotation. The results demonstrate that the design approach is viable and efficient, and is therefore useful for the preliminary design of the generator. In addition, it is found that smaller tape width, larger distance between the superconducting coils in the same slot, smaller coil number in one slot and lower working temperature can reduce the AC loss of the stator coils, but the reduction of the AC loss needs careful design to achieve an optimum solution.

Design of a Dual-Stator Superconducting Permanent Magnet Wind Power Generator with Different Rotor Configuration

Design Of A Dual-Stator Superconducting Permanent Magnet Wind Power Generator With Different Rotor Configuration

Design of A 10 Mw Dual-Stator Superconducting Permanent Magnet Wind Power Generator

Design Aspects for Permanent Magnet Superconducting Wind Power Generators

Comparison of Dual-Stator Permanent Magnet Machines with Different Rotor Topologies

Enhanced Ventilation and Thermal Performance by Skewed Through Holes on Rotor Yoke in Forced Air-Cooled Permanent Magnet Wind Generators

Design and Analysis of an Outer-rotor Stator-Doubly-Fed Doubly-Salient PM Machine for Wind Power Generation

Electromagnetic Design And Optimization Of Dual-Stator Brushless Doubly-Fed Wind Power Generator With Cage-Barrier Rotor

Design and Analysis of Axial Flux Permanent Magnet Generator for Direct-Driven Wind Turbines

Design and Performance Analysis of Dual-Stator Brushless Doubly-Fed Machine with Cage-Barrier Rotor

Comparison of Electromagnetic Performance of Superconducting Permanent Magnet Wind Power Generator with Different Topologies

Design and Analysis of a Cost-Effective Magnetless Multiphase Flux-Reversal DC-Field Machine for Wind Power Generation

A feasibility study on a new brushless and gearless contra-rotating permanent magnet wind power generator

Analysis of Dual-Armature Flux Reversal Permanent Magnet Machines with Halbach Array Magnets

Design and Analysis of an Air-Cored Axial Flux Permanent Magnet Generator for Small Wind Power Application

An Electromagnetic Design of a Fully Superconducting Generator for Wind Application

A Pole Pair Segment of Oil-cooling Air-Core Stator for a 2 MW Direct-Drive High Temperature Superconducting Wind Power Generator

Analysis and Experiment of a Dual StatorRotor PM and Winding Flux Modulated PM Machine

Inner Evaporative Cooling Wind Power Generator With Non-Overlapping Concentrated Windings

Design and Optimization of Halbach-Array PM Rotor for High-Speed Axial-Flux Permanent Magnet Machine With Ironless Stator

Design and Characteristic Investigation of Novel Dual-Stator V-Shaped Magnetic Pole Six-Phase Permanent Magnet Synchronous Generator for Wind Power Application