Abstract:For high precision measurements, accelerometers need recalibration between different measurement occasions. In this paper, we derive a simple calibration method for triaxial accelerometers with orthogonal axes. Just like previously proposed iterative methods, we compute the calibration parameters (biases and gains) from measurements of the Earth's gravity for six different unknown orientations of the accelerometer. However, our method is non-iterative, so there are no complicated convergence issues depending on input parameters, round-off errors, etc. The main advantages of our method are that from just the accelerometer output voltages, it gives a complete knowledge of whether it is possible, with any method, to recover the accelerometer biases and gains from the output voltages, and when this is possible, we have a simple explicit formula for computing them with a smaller number of arithmetic operations than in previous iterative approaches. Moreover, we show that such successful recovery is guaranteed if the six calibration measurements deviate with angles smaller than some upper bound from a natural setup with two horizontal axes. We provide an estimate from below of this upper bound that, for instance, allows 5° deviations in arbitrary directions for the Colibrys SF3000L accelerometers in our lab. Similar robustness is also confirmed for even larger angles in Monte Carlo simulations of both our basic method and two different least-squares error extensions of it for more than six measurements. These simulations compare the sensitivities to noise and cross-axis interference. For instance, for 0.5% cross-axis interference, the basic method with six measurements, each with two horizontal axes, gave higher accuracy than allowing 10° deviation from horizontality and compensating with more measurements and least-squares fitting.

Maximum Likelihood Approach for Low-Cost MEMS Triaxial Accelerometer Calibration

Maximum likelihood calibration for MEMS triaxial accelerometer

Minimum Settings Calibration Method for Low-Cost Tri-Axial IMU and Magnetometer

Systematic Calibration Method for the Nonlinear Coefficients of Triaxial Accelerometers

A Research on Calibration of Low-Precision Mems Inertial Sensors

Thermal Calibration of Triaxial Accelerometer for Tilt Measurement

An Improved Method for the Magnetometer Calibration Based on Ellipsoid Fitting

A Survey of Error Analysis and Calibration Methods for MEMS Triaxial Accelerometers

Anin Situhand Calibration Method Using a Pseudo-Observation Scheme for Low-End Inertial Measurement Units

Low-Cost Inertial Measurement Unit Calibration with Nonlinear Scale Factors.

Low Cost Attitude Determination System for Accelerated Rigid Bodies

In-Field Gyroscope Autocalibration with Iterative Attitude Estimation

A Field Calibration Approach for Triaxial MEMS Gyroscopes Based on Gravity and Rotation Consistency

A new calibration method for MEMS accelerometers with genetic algorithm

A Novel Tri-Axial MEMS Gyroscope Calibration Method over a Full Temperature Range

Calibration method of strapdown inertial measurement unit based on two-axis turntable

Initial Calibration of MEMS Inertial Measurement Unit

Simple non-iterative calibration for triaxial accelerometers

Robust Equipment-Free Calibration of Low-Cost Inertial Measurement Units

Study on Calibration Method for Tri-Axial Accelerometers

Compounded Calibration Based on FNN and Attitude Estimation Method Using Intelligent Filtering for Low Cost MEMS Sensor Application