B12-P-05Large Plasticity of Single Crystalline Nano-Sized Mo

Yan Lu,Lihua Wang,Ze Zhang,Xiaodong Han
DOI: https://doi.org/10.1093/jmicro/dfv225
2015-01-01
Microscopy
Abstract:It's well known that screw dislocation controls the plastic deformation of body-centered cubic (BCC) metals both in bulk and nanoscale sample. The low mobility and entanglement of screw dislocation leads to poor plasticity of BCC metals. Previous studies demonstrate that the elongation of single crystal Mo nanowire (with diameter of ∼300nm-500nm) is less than 10% [ 1 ]. Here, with our homemade transmission electron microscopy (TEM) tensile device, the in situ tensile texts were conducted on the Mo nanowire. The results show that, with the size decreasing, large elongation of Mo nanowire was obtained. Figure 1 a shows the morphology of nanowire that fabricated by focus ion beam technique, the nanowire with a width of 220nm and long axis along <110> direction. Comparing the elongated length (Figure 1 b) with the initial length (Figure 1 a), the nanowire exhibits homogeneous strain of ∼22% before fracture. The large plastic elongation of Mo nanowire is caused by fast motion ability of dislocations. While suffering stress, dislocations nucleate and sequentially move towards surface. Although the screw dislocation in BCC metals likely undergoes self-propagation process [ 2 ], the small volume and large free surface of nanowire leads to the dislocations quickly escaping from surface. The continuous dislocation nucleation and escape from free surface contribute the large plastic deformation of Mo nanowire.
What problem does this paper attempt to address?