Abstract:To enhance the toughness of metallic glasses (MGs), considerable scientific efforts have been made to investigate the physical mechanism of fracture behavior of MGs in past few years. However, many unresolved puzzles remain about the fracture mechanisms of MGs at present. In this paper, Molecular Dynamics (MD) simulations have been used to investigate the tensile fracture behavior of Al based MGs under nine different Engineering strain rates. Our results show that the higher the Engineering strain rate is, the longer the period of plastic deformation, the shorter the crack length. we have observed that Al amorphous with notch gradually crystallizes during tensile fracture, however, there are differences in the degree of crystallization and atomic arrangement as well as micro-structure in different regions with different Engineering strain rates. In the process of tensile fracture of Al based MGs, the crack propagation mainly along the hexagonal-close-packed (HCP) grain boundaries between face-centered-cubic (FCC) crystal blocks. As the Engineering strain increases, numerous HCP atoms located at grain boundaries gradually migrate into the interior of FCC crystal blocks, the velocity of crack propagation will also increase and finally induce the brittle fracture of Al based MGs. Meanwhile, we effectively demonstrated the existence of HCP and FCC atoms in Al based MGs during tensile deformation by analyzing the bond-orientational order parameters q l . The analysis of thermodynamics (entropy) showed that there is a positive correlation between the Engineering strain rate and the strain of maximum entropy when the Engineering strain rate exceeds 0.002 ps -1 . The formation of cavitation ahead of crack could be attributed to the migrate of atoms from the higher entropy cavity region to the lower entropy crystallization region. This study enriches the traditional tensile deformation theories and provides a new understanding for the physical origins of cavitation in the crack tip of MGs.

Processing Effects on Fracture Toughness of Metallic Glasses

Intrinsic and Extrinsic Effects on the Fracture Toughness of Ductile Metallic Glasses

Atomistic Investigation of the Intrinsic Toughening Mechanism in Metallic Glass

Effect of chemical composition on the fracture toughness of bulk metallic glasses

Understanding the Fracture Behaviors of Metallic Glasses—An Overview

Brittleness of metallic glasses dictated by their state at the fragile-to-strong transition temperature

Composition-dependent fracture energy in metallic glasses

Locating bulk metallic glasses with high fracture toughness: Chemical effects and composition optimization

How the Toughness in Metallic Glasses Depends on Topological and Chemical Heterogeneity

Compressive fracture morphology and mechanism of metallic glass

Elevating the Fracture Toughness of Cu49Hf42Al9 Bulk Metallic Glass: Effects of Cooling Rate and Frozen-in Excess Volume

Temperature Effect on Fracture of a Zr-Based Bulk Metallic Glass

The influence of Engineering strain rates on the atomic structure, crack propagation and cavitation formation in Al based metallic glass

Crack tip cavitation in metallic glasses

Mechanical glass transition revealed by the fracture toughness of metallic glasses

Strength Softening at Shear Bands in Metallic Glasses

The Effect of Matrix Fracture Toughness on the Plastic Deformation of the Metallic Glassy Composite

Fracture toughness and destructive mechanism of ductile nanoporous metallic glass and its crystal-impregnated nanocomposite

Intermediate Temperature Brittleness in Metallic Glasses

Fracture in metallic glasses: mechanics and mechanisms

Electronic structure based design of thin film metallic glasses with superior fracture toughness