Abstract:<p>Feed spacer is universally used in spiral-wound nanofiltration (NF) and reverse osmosis (RO) membrane modules. It can separate membrane sheets, create flow channels, promote turbulence and enhance mass transfer. However, it also induces increased pressure drop across the flow channel, and generates dead zones for biofilm growth at specific locations. Optimization of feed spacer geometries is highly desirable for energy saving and biofouling control. In this study, four kinds of commercial feed spacers featured with non-uniform filaments were compared in terms of hydraulic and anti-fouling performances. Computational fluid dynamics (CFD) simulations were launched to give insights into the impacts of feed spacer characteristics on the flow field. Results show that the hydraulic performance was substantially affected by the number of filament layers (single or dual layer), the non-uniformity of filament diameter and the width of thinning zones. The design of single layer feed spacer of non-uniform filaments was not recommended due to the high flow resistance and poor anti-fouling performance. The feed spacer structure of alternating filament diameter contributed to reducing dead zones and alleviating membrane fouling. The thinning zones located adjacent to the filament junctions achieved better anti-fouling performance, as it disturbed the dead zones and partially washed away the deposited foulants. This study demonstrates for the first time that the characteristics of non-uniform filament feed spacer had a crucial impact on the hydraulic and anti-fouling performances, and suggests that more emphasis should be laid on number of filament layers, variation of filament diameter and width and positioning of thinning zones for the optimization of feed spacer geometries in the future.</p>

Cfd Simulations of the Fluid Flow Behavior in A Spacer-Filled Membrane Module

CFD simulations of different spacer geometries in plate-and-frame modules

Dissecting spacer induced membrane deformation and fluid hydraulic behavior in reverse osmosis

Impacts of non-uniform filament feed spacers characteristics on the hydraulic and anti-fouling performances in the spacer-filled membrane channels: Experiment and numerical simulation

Study of spacer structure on the enhancement of heat and mass transfer in direct contact membrane distillation modules

Hydrodynamic effects of the elliptical spacer filament on the flow and mass transfer in a desalination membrane channel

Impact of non-Newtonian fluid behavior on hydrodynamics and mass transfer in spacer-filled channels

Surrogate modeling of pressure loss & mass transfer in membrane channels via coupling of computational fluid dynamics and machine learning

Effects of Rectangular-Type Spacer on Hert Transfer and Flow in Coolant Passage.

Simulation of flow around two rotating cylinders in a side-by-side arrangement at long channel using LB-DF/FD method

Influence of Geometry Structures on the Transfer and Flow Characteristics of Membrane Modules

A computational fluid dynamics study on TPMS-based spacers in direct contact membrane distillation modules

Simulation of Flows Around Two Tandem Rotating Cylinders in a Channel Using LB-DF/FD Method

A Fundamental-Study of the Heat-Transfer and Flow Situation Around Spacers (A Single Row of Several Cylindrical Rods in Cross Flow)

Application and performance of Dean vortices flow with spiral modules on membrane separation

Impact on Fluid Flow State by Different Structural Parameters of Immersion Lithography Unit

Simulation of Flow and Heat Transfer in Micro Couette Flow

Dynamic Evolution of Membrane Biofouling in Feed Channels Affected by Spacer–membrane Clearance and the Induced Hydrodynamic Conditions

A fundamental study of the heat transfer and flow situation around a spacer (In the case of a circular cylinder as a spacer.

Analysis of Concentration Polarisation in Full-Size Spiral Wound Reverse Osmosis Membranes Using Computational Fluid Dynamics

WALL EFFECTS ON FLOWS PAST TWO TANDEM CYLINDERS OF DIFFERENT DIAMETERS