Abstract:The development of Smart Grid requires more accurate and fast for perception, assessment and control of power system state. Widely installed phasor measurement units (PMU) and mass PMU measurements provide a good foundation for this requirement, because PMU can directly measure bus voltage phasors at the rate of tens of milliseconds. Thus, the number of PMU installed in the power grid and the reliability and accuracy of PMU measurements are of great importance, which directly affect the feasibility and reliability of state perception. Actually, PMU measurements may contain bad data and the accuracy of phase measurements is not high enough.Estimation method is an effective way to deal with data contaminated by noise and bias. In this paper, we proposes the complex number weighted least squares (CWLS) estimation algorithm to process PMU measurements directly in the complex domain to obtain more accurate system state. Phasor error characteristics in the complex domain are analyzed depth which shows the proposed algorithm is robust to phase error. Meanwhile, an effective bad data identification method is proposed. Test results demonstrate the performance of the CWLS algorithm from the perspectives of computional efficiency, estimation quality and adaptability to inconsistent measurment errors, the robustness of the CWLS algorithm and the effectiveness of the proposed bad data identification method is also shown in the tests.

Experimental Measurement of PMU Error Distribution and Its Impact on Load Model Identification

Experimental Test of PMU Measurement Errors and the Impact on Load Model Parameter Identification

Electric Load Modeling for Wide Area Power Systems

Frequency Parameter Identification and Impact Analysis of Load Based on Measured Data

Modeling Methods for Electric Loads in a Real Power Grid

Study on state estimation with PMU equipped at partial nodes of power systems

Improvements and measurements of parameter identification for electric load

Optimal PMU Placement Approach for Power Systems Considering Non-Gaussian Measurement Noise Statistics

Wide-area measurement system based power load modeling

Power System State Estimation Based on PMU under Linear Bayesian Theory

Transmission Lines Positive Sequence Parameters Estimation and Instrument Transformers Calibration Based on PMU Measurement Error Model

A low-quality PMU data identification method with dynamic criteria based on spatial–temporal correlations and random matrices

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

State estimation for distribution systems using micro-synchrophasors

Real-time Topology Analysis Method for Power Network Based on Sparse PMU Placement

Approach to Enhance the Robustness on PMU Based Power System Dynamic Equivalent Modeling.

Data Improvement for Ambient Signal Based Load Modeling Via Wide-Area State Estimation

Research on Perception of Power System State Based on Wams

Optimal PMU Design Based on Sampling Model and Sensitivity Analysis

Optimum Placement of Phasor Measurement Units in Power Systems.

Gaussian Mixture Models and its Parameter Estimation to Describe the Distributions of PMU Random Errors in Power Systems