Abstract:Purpose A 3D finite element (FE) model based on the double ellipsoidal heat source was developed to investigate the evolution of temperature and stress fields during the multilayer and multi-pass wire and arc additive manufacturing (WAAM) process. This paper aims to investigate the evolution of temperature and stress fields during the multilayer and multi-pass wire and arc additive manufacturing (WAAM) process by developing a 3D finite element (FE) model based on the double ellipsoidal heat source. Design/methodology/approach Experimental thermal cycle curves and residual stresses were obtained by thermocouples and X-ray diffraction, respectively. The validity of the model was verified by the corresponding experimental results. Findings The deposition process of the upper pass led to the partial remelting of the lower deposited pass. The thermal process of the current-deposited pass alleviated the stress concentration in the previous-formed passes. A more uniform temperature distribution could be obtained by using the reciprocating deposition path. Compared to the reciprocating deposition path, the peak values of the transverse and longitudinal tensile residual stresses of the deposited sample under the unidirectional deposition path were reduced by 15 MPa and increased by 13 MPa, respectively. The heat conduction in the deposited passes could be improved by extending the inter-pass cooling time appropriately. With an increase in the inter-pass cooling time, the longitudinal residual stress in the middle region of sample along longitudinal and transverse directions showed increase and decrease–increase trends, respectively, while the transverse residual stress exhibited decrease trend. Originality/value This study enhances the understanding of temperature and stress fields evolution during the multilayer and multi-pass cold metal transfer-WAAM processes of magnesium alloy and provides the reference for parameter optimization.

Optimisation of Interpass Temperature and Heat Input for Wire and Arc Additive Manufacturing 5A06 Aluminium Alloy

Impact of Process Parameters on Forming Quality and Deposition Efficiency of Unsupported Rods in Wire Arc Additive Manufacturing

Heat Input Adjustment Process for Unsupported Aluminum Alloy Lattice Struts Continuous Forming by Wire Arc-Directed Energy Deposition

Formation and Improvement of Surface Waviness for Additive Manufacturing 5A06 Aluminium Alloy Component with GTAW System

Thermal Boundary Evolution of Molten Pool During Wire and Arc Additive Manufacturing of Single Walls of 5A06 Aluminum Alloy

Regional Control and Optimization of Heat Input during CMT by Wire Arc Additive Manufacturing: Modeling and Microstructure Effects

Effect of Induction Heat Treatment on Residual Stress Distribution of Components Fabricated by Wire Arc Additive Manufacturing

A computationally efficient thermo-mechanical model for wire arc additive manufacturing

Numerical simulation of thermal and stress fields for multilayer and multi-pass weaving WAAM of magnesium alloy

Effects of Heat Input on Morphology of Thin‐Wall Components Fabricated by Wire and Arc Additive Manufacturing

On the Effect of Heat Input and Interpass Temperature on the Performance of Inconel 625 Alloy Deposited Using Wire Arc Additive Manufacturing–Cold Metal Transfer Process

Numerical Study of Heat Transfer Characteristics in Positional Wire and Arc Additive Manufacturing

A Heat Transfer Finite Element Model for Wire-Arc-Additive-Manufacturing Process

Process Planning Strategy for Wire-Arc Additive Manufacturing: Thermal Behavior Considerations

A numerical model-based deposition strategy for heat input regulation during plasma arc-based additive manufacturing

Efficient Manufacturing of Al–Mg Alloys Using Controlled Low Heat Input Wire and Arc Additive Manufacturing

Development of a New Cold Metal Transfer Arc Additive Die Manufacturing Process

Numerical simulation for microstructure control in wire arc additive manufacturing of thin-walled structures

Thermoelectric Cooling-Aided Bead Geometry Regulation in Wire and Arc-Based Additive Manufacturing of Thin-Walled Structures

Thermal Behavior in Wire Arc Additive Manufacturing: Characteristics, Effects and Control

Microstructure characteristics under varying solidification parameters in different zones during CMT arc additive manufacturing process of 2319 aluminum alloy