Abstract:Understanding the mechanical response of a high-speed penetrator penetrating icy lunar regolith (ILR) is essential for designing penetrators in lunar permanently shadowed regions and interpreting the detection data from the device. Experimental research on the penetrators is limited in engineering due to the difficulties in preparing large-scale icy lunar regolith simulants (ILRS). Such limitation urges the need to construct a theoretical model and verify a numerical simulation model based on the scaled-down penetration experimental results, which provide insights into the mechanical response of penetrator penetrating ILR. Projectile penetration experiments were conducted on ILRS targets with four typical water content levels in a cryogenic chamber at 110 K. The experimental results show that the ILRS with higher water content exhibits greater brittleness and a faster crack growth rate. Consequently, the diameters of cratering and scabbing areas are augmented on the target surface upon projectile penetration. Moreover, increased mechanical strength decreases the plugging height on the ILRS targets. Based on the projectile residual velocities, the equivalent target strength parameter R were calculated and fitted to a functional relationship with the uniaxial compressive strength. RHT model parameters were calibrated using the test results of the dynamic and static mechanical properties of the simulants. Numerical simulation of projectile penetration into semi-infinite and thick targets were conducted using the calibrated model. The simulation results demonstrate high consistency with the experimental and theoretical calculations, indicating the effectiveness of the constitutive model in describing the mechanical response of the ILRS under projectile penetration.

Modeling and Experimental Validation for Hammer-Driven Type Penetrators under Horizontal Condition

Study on Optimization of Structure Parameters to the Penetrator

Investigation on the anti-penetration performance of the steel/nylon sandwich plate

Study on the dynamic characteristics of a hammer-driven-type penetrators in the penetration process

Design and Simulation Research on New Tamper Based on ADAMS

Penetrator Penetrating Lunar Soil: Accurate Modeling and Parameter Analysis

Numerical Simulation on Interaction Process Between Impact Penetrator and Lunar Soil Particles for Lunar Subsurface Exploration

The Study on Penetration of Constant Kinetic Energy Long-rod Penetrator and Optimal Design

Analysis of the influence of different initial velocities on dynamic performance of multi-layer hard target penetration process

Development of Johnson-Cook-Distinct Lattice Spring Model and its application in projectile penetration into metal targets

Study on the Penetration Characteristics of Deep Space Impactor into Concrete

A NEW THEORETICAL MODEL FOR ARMOR-PIERCING MECHANICS

Penetration Analysis of Driving Weapons Precursory Shaped Charge Based on LS-DYNA

Design of a Hammer-Driven Type Robot(hdr) for Planetary Subsurface Exploration

Energy transfer efficiency and rock damage characteristics of a hydraulic impact hammer with different tool shapes

Experimental Studies on Kinetic Projectile's Direct Penetrations with Low-speed Against Reinforced Concrete Targets

A study of high-velocity penetration on icy lunar regolith simulants

Numerical Simulation of Penetration in Concrete Sheet Based on SPH Method

Transformation Mechanism of Dual-mode Penetrators Achieved by Changing of Single-point Detonation

Two novel approaches for solving the contradiction between efficient penetration and low recoil for the low‐velocity penetrator

Numerical Simulation of Impact on Pneumatic Dth Hammer Percussive Drilling