Creep Life Prediction of Small Punch Creep Testing Specimens for Service-Exposed Cr5Mo Using the Theta-Projection Method

Yangyan Zheng,Sisheng Yang,Xiang Ling
DOI: https://doi.org/10.1016/j.engfailanal.2016.11.009
IF: 4
2016-01-01
Engineering Failure Analysis
Abstract:In this paper, small punch creep tests under different loads and conventional creep tests with various stresses at 550°C were conducted on service-exposed Cr5Mo material. The theta-projection and modified theta-projection methods were used to analyze the creep curve and the minimum creep rate. The actual fracture time in the small punch creep test was 377h, and the theta-projection method predicted a time of 339h, which represents an error of 10.08%. The predicted time from the modified theta-projection method was 316.25h, which represents an error of 16.11%. The curves predicted by the two models are similar. The theta-projection method is suitable for applications in small punch creep life analysis.
What problem does this paper attempt to address?