Synergistic Effect of Fe2O3/Ho2O3 Co-modified 2D-Titanate Heterojunctions on Enhanced Photocatalytic Degradation

Pei Wu
DOI: https://doi.org/10.1016/j.solidstatesciences.2016.11.009
IF: 3.752
2017-01-01
Solid State Sciences
Abstract:TiO2-based nanosheets (TNSs) co-modified by Fe2O3 and Ho2O3 were synthesized by one-pot hydro thermal method using Fe(NO3)(3) and Ho(NO3)(3) as precursors compositing with TiO2. The Fe2O3/Ho(2)O(3)TNS5 heterojunctions possessed a thickness of approximately 3-4 nm, large specific surface area of 210 310 cm2/g, with Fe2O3 and Ho2O3 nanoparticles highly dispersed over the surface of the nanosheets. The crystallization of the samples gradually increased with the amount of Fe2O3 nanoparticles, which was confirmed by the XRD, BET and Raman spectra, indicating that Ho2O3 and Fe2O3 influenced the crystallinity and structure evolution of the TNSs, besides, led to an improved the visible-light absorption. Surface photocurrent and fluorescence spectral studies revealed that the photo-generated charge carrier separation efficiency could be efficiently improved by an appropriate amount of modification. The Fe2O3/ Ho2O3-TNS5 exhibited synergistic effect on photocatalytic degradation of RhB as well as MO under visible light. The highest efficiency was obtained by 0.05%-Fe2O3/Ho2O3-TNS5 (Fe:Ho:Ti = 0.05:1:100), which was 8.86 and 6.72 times than that of individual 1.0%-Ho2O3-TNS5 (Ho:Ti = 1:100) and 0.05%-Fe2O3-TNSs (Fe:Ti = 0.05:100), respectively. The possible mechanism for enhanced visible-light -induced photo catalytic activity was proposed. Ho2O3 introduced in the photocatalysts may act as the hole capture while Fe2O3 may share the same Fermi levels with TNSs and serve as the electron capture center in the n-n-p system, which reduced the recombination rate of photo-induced electron-hole pairs. (C) 2016 Elsevier Masson SAS. All rights reserved.
What problem does this paper attempt to address?