Abstract:Minimum-mean-square-error (MMSE) detection is becoming increasingly relevant in signal detection for massive multiple-input-multiple-output systems because of the increasing numbers of both users and antennas. This paper proposes a signal detection method called parallelizable Chebyshev iteration (PCI) that reduces the computing load and explores the potential parallelism of matrix inversions and multiplications, which are both major issues in MMSE detection. First, an eigenvalue-approximation-based method is used to obtain an initial solution. Then, optimized Chebyshev iteration is applied for the approximate computation of matrix inversions and multiplications. The number of multiplications is reduced from O(BU2 + U-3) to O(KBU), where B, U, and K are the numbers of antennas, users and iterations, respectively. The PCI method eliminates the correlations in large-scale matrix inversions and multiplications, thereby improving the parallelism among elements of the estimated vector. These improvements are achieved at the cost of a minor reduction in detection accuracy. Based on the PCI method, a very-large-scale-integration fully pipelined architecture is proposed to realize 128 x 1664-QAM MMSE detection. Here, the iterative parameters are obtained through approximate computations and are used repeatedly, and the user-level pipeline processing pattern achieves an optimal tradeoff among the throughput, area, and power. This architecture was verified on an FPGA, and the layout was implemented using TSMC65 nm 1P9M CMOS technology. Results of 2.46 Gbps/W (throughput/power) and 0.53 Gbps/mm(2) (throughput/area) were obtained, which represent increases of 4.56 x and 3.79 x, respectively, compared with current state-of-the-art designs.

Large-Scale Mimo Detection Design and Fpga Implementations Using Sor Method

Design of Highly-Parallel, 2.2gbps Throughput Signal Detector for MIMO Systems

Large-Scale MIMO Detection for 3GPP LTE: Algorithms and FPGA Implementations

Design of a Configurable MIMO Detector Based on the FPGA

An Efficient Massive MIMO Detector Based on Second-Order Richardson Iteration: from Algorithm to Flexible Architecture.

Efficient and Flexible VLSI Architecture for Soft-Output Massive MIMO Detector

Design and Implementation of Stochastic Computing Based Massive MIMO Detector

FPGA Implementation of Feature Detection Algorithm Based on High Level Synthesis

Design and Implementation of IEEE 802.16 MIMO Detection on FPGA

Stochastic Iterative MIMO Detection System: Algorithm and Hardware Design

Algorithm and VLSI Design for 1-bit Data Detection in Massive MIMO-OFDM

MIMO Signal Detector Based on Reconfigurable K-Best

Low-Computing-Load, High-Parallelism Detection Method Based on Chebyshev Iteration for Massive MIMO Systems with VLSI Architecture

A high performance massive MIMO detector based on log-domain belief-propagation

A Partial Inter-Layer Parallel Sphere Decoder for Multiple-Input Multiple-Output Systems

Dynamic Reconfigurable Chips for Massive MIMO Detection

A 1.1-Gb/s 115-Pj/bit Configurable MIMO Detector Using 0.13- $\mu\hbox{m}$ CMOS Technology

A 1 . 1Gb / s 115-pJ / bit Configurable MIMO Detector Using 0 . 13-μ m CMOS Technology

A Parallel Early-Pruned K-Best MIMO Signal Detector Up to 1.9Gb/s.

Hardware Efficient Signal Detector Based on Lanczos Method for Massive MIMO Systems

Rethinking Massive MIMO Detection: A Memristor Approach